Bathroom Fan Ceiling Mount Exhaust Ventilation Fan Ceiling Exhaust Fan Extractor Fan 141 CFM 1.2 Sones,Quiet Bathroom Ventilation Exhaust Fan for Shower,Restroom,Office,Home(Flat Plate)

Muy bueno y cómodo para el baño hace un buen trabajo es muy efectivo y tiene buena luz y absorbe toda la humedad de

Me gustó mucho Luce bonito 🤩 material se ve de buena calidad. Recomendado

The vent made a huge dirrence to my bathroom. It wasn't to loud. Great value for what I paid. Easy to install and maintain. I connected it to my light switch with ease.

No me gusto que tiene los orificios para sujetar demasiado cerca de la orilla es muy difícil para atornillar y los tornillos que trae están demasiado pequeños tuve que usar unos tornillos mas largos para sujetar a la madera y los meti de lado para poder sujetar y no supciona mucho el vapor se convierte en agua sobre el extractor y cae al piso, creo que el motor es muy pequeño, tal vez necesite uno con mas potencia

This fan is very quiet and moves a lot of air out of a bathroom we use as a smoking room during the winter.. The squirrel cage fan and open grate creates a vortex that sucks the smoke out in a hurry. We don't need to use air freshener all the time any more. However, it is not a quiet as suggested, about the same as our dishwasher. But it is 80% quieter than the old propeller fanInstallation is tricky, but what do you expect from an inexpensive fan?1. Using naked barrier strips to romex is not code nor is it safe. I used a 3' grounded AC cable cut off from an old tool, crimp connected it to the fan wire and wrapped with electricians tape. I put a Jbox with dual outlet on the joist to plug it into. This might not be exactly code, but it is safe if you are good with a crimp tool and tape.2. It is tricky to install this fan in a drop ceiling. You cant just screw it into ceiling tile -- the tile will sag and/or the fan will fall out. I cut 2 pieces of 26" long pine 1x2 to set on top of the grid. Those go on either side of the fan parallel with the fan outlet. 2" drywall screws with washers screwed it through the 2x2 drop ceiling and into the pine supports.Note: Install it in a panel that has a removable panel on both sides. You need access on both sides of the fan to hold the wood in place on top while you put the screw in from the underside, with somebody else holding the fan up in the hole while the screws are installed.3. The fan outlet has no ribs to keep the hose from popping off. The usual hand spring is not strong enough to keep the hose attached. To do it right you will need a 6" metal band clamp to connect the flex duct to the fan. Duct tape won't work, nothing to attach it to on the fan.It would be nice if Jinhong would put ribs on the outlet and provide a small plastic jbox with rubber cord seal for the wire going to the fan and with romex connector on the other side. It would also be nice if the fan wire were a bit long, say 1 meter.

Buen producto

I can hear the fan coming on but even when blowing smoke right at it it doesn’t suck it out

great value