Nilight 16 AWG 10 Feet 2-pin DT Connector Wiring Harness Extension Kit

I had a set of 3” Nilight pod lights with wiring harness to install as rear lights on my Ranger 570 SP. The Nilight harness with relay was great! But it was too short to keep the relay and fuse in the front compartment on the pulse panel. These were the perfect solution! The extensions are plugged in under the tunnel to each of the individual light leads from the Nilight harness. And there was just enough length to run behind the seat back, up the driver side roll bar, and to each light. (Had about 1’ too much for passenger side light, so should be fine for full-size Ranger too.) Now have a weatherproof, factory quality installation with no splices or solder joints. The only mods I had to make for the entire install (not related to these extension cables) were: 1) Cutting the ring lugs off and adding waterproof heat shrink butt splices to Polaris pulse plug, and 2) Buying a factory-style Carling L1 illuminated switch to replace the round switch provided. (This is a direct plug and play too since the Nilight switch wiring has 1/4” faston connectors.)

This was perfect for me. I had two lights bars in my rear bumper and needed to extend the harness to my fuse block. Great value

Worked great. Plugged in with no problem.

Used them to install Morimoto 2 Banger pods on my vehicle. Casing for the wires is thick enough that will stand the weather and abrasion. I spliced them to make just one run, added braided sleeving (for looks and additional protection). The wire quality and thickness made the connection with waterproof connectors strong and durable. Saved me around 20 dollars as compared to brand name wires.

I bought a lightbar from Harbor Freight, to put on the back of my enclosed trailer. Their wiring kit doesn't really cover anything over maybe 10-12 ft, but I have a 20 foot long trailer and I need to run wires up, along the wall, and across the back. 2 of these gave me the extension that I needed and they plug right into the HF wiring harness, so I don't have to do any additional splicing.

I used these to plug in my mopar lights for my wrangler. Matched right up to the factory plugs.

Good value, inexpensive way to extend other wiring. Decent materials and seem close to OEM.

Exelente

Good quality. Used these on my dirt bike to wire up a rear light.

parfait

Good