3M Scotchgard Clear Paint Protection Bulk Film Roll 6-by-72-inches

Good quality product, did not work well on the bow of my boat where the roller hits it. It just wrinkled it up and made it start coming off. This products is not a protector for for the bow keel, I wanted to see if it would work for this application. It was easy to install and remove when it didn’t work for my experiment. Good product, but not for where something is going to rub hard against it.

Thick material, easily cut with straight edge and sharp blade, used spray bottle with bottled water snd and a few drops of dish soap, sprayed back of film and placed on bike frame. A lot cheaper than buying pre cut kits

Stretches to fit, used this on rocker panels with enough left to put on the rear quarter panel. Custom splash shields (mud flaps) are $150 each, yeah each, not for a set, so decided to try the "Clear Bra" instead. A bit tricky to install for one person, but starting with the front bottom and moving back and up on a progressive basis with a squeegy sold for the job got it done. Things need to be clean, but this isn't quite as sensitive to microscopic dust as a tablet/phone screen. Nearly invisible.

If you can't tell where the 3M clear guard is applied it is likely because I chose a smaller thickness and this stuff is plain excellent in transparency. I suggest wrapping under to conceal edges where possible. Areas applied circled in blue. At least it works on my Ford's! GTC Cervini Mustang 2008: Exhaust protected due to low ground clearance. Do not apply to exhaust or near exhaust, for this go with 3M Carbon fiber or have every little crack replaced. Otherwise use for guarding high points on low body effects. F-150 XLT Texas Edition 2001: Works excellent as a general front guard - took extra time and patience to protect the rear view mirrors, yet this stuff is pliable in excellent fashions. Shelby GT500 Cobra Mustang 2009: Protecting emblems and original Red Stripe

The product looks like 8mm and has good adhesiveness feel to it. I can tell the quality is quite good. I give it 3 stars overall based on the jagged edges. Both sides of the short edges aren’t cut clean and visually you can see the jagged lines, so I can’t use it as a straight edge and have to cut off the jagged lines, that means more work. It doesn’t matter if your project doesn’t involve straight lines but mine does.

I use this product on commercial vehicles to protect inspection stickers and mandatory stickers (HUT & IFTA) when they go through pressure washing. We’ve used it for several years and the stickers last through weekly or more frequent washing. Very good product.

Not easy to install

I will accept some of the blame for this product not working but not all. It is pretty thick and my application area was clean an dust free but it would not go on wihout air bubbles. Ill use the left over for other projects