Door Window Moulding Trim Seal Outside Belt Weatherstrip Fit for Toyota FJ

Perfect fit for my 08 FJ Cruiser. Installation was faster and easier than removing the factory pieces.

Really easy to install and looks great. Used on my 2011 Tundra. Took longer to take the originals off than it did to install the new ones. All I needed was a thick blade screwdriver inserted between the seal and the door to pop off one side of the old ones, then twisted as I pulled them up and off. New ones aligned perfectly. Would suggest using a folded washcloth and rubber mallet to get them to seat correctly, you will hear them click into place. Pretty simple. Took maybe 20 minutes total and didn't have to remove the door panel to do it.

First sent me the wrong item. Once I got these I found that 3 out of 4 of the seals do not fit. One of the rear seals has 3 clips as it’s supposed to and the other only has 2, leading to loose fitment. The end of the driver seal does not clip in on the end. The passenger seal does not clip in on the end and has a bow leading to loose fitment

Great off the box no bends on moulding

These work and fit exceptionally well

Fit perfectly. Easy to install

I bought them for a FJ Cruiser, and right out of the box I noticed that they are molded incorrectly. This is the same problem many people were having. The rear tabs are too wide and need to be cut back. I cut about 15% off from the front side of both tabs. You can see it clearly in the picture where they're laying flat against the original trim. I honestly wouldn't recommend buying these unless you think you could fix them yourself. I used a box cutter and double sided tape to stick the back side to the door. I gave 3 stars because once you fix them; they fit really nice, and they press hard against the window to ensure no water leaks in. Buy at your own risk!

I did a lot of research before pulling the trigger on these replacement seals for my 2007 Toyota Tundra and can assure you that these are the ones to buy. These seals fit perfectly, though I highly recommend buying an inexpensive set of car trim removal tools both to remove the original seals and insert the new ones. The flat-edged tool is essential in snapping the new seals into place by going along the inside pocket and applying pressure along the entire length to keep the seal from raising up. Start to finish this was a 15-minute job and the new seals look amazing. Packaging and overall quality of the product was top notch.

It's looks identical to the OEM part but if I install it on my FJ cruiser it just doesn't fit as an OEM part. Quality wise it's also completely different. OEM part lasted 8 years in dubai summers.

Ils étaient trop court…😐

Llegó a tiempo y se ajustó muy bien