A-Premium Turbocharger Gasket Kit

Got this for my 2014 1.4l chevy cruze. Worked great for all the seals. I didn't use the bolts so can't comment if they fit or not.

Studs are too long.

Exhaust studs are not for a 2014 Cruze. Therefore they dont screw all the way into cylinder head and to long.

Studs were to long had to use the old ones

China junk does not fit not machined to proper specs. Mounting studs too long have to cut to proper length with a cut off wheel or purchase metric nuts from hardware store because barrel nuts provided will not work with studs provided unless studs are cut down.

I would give this kit a five star for its value and complete assortment of gaskets needed when installing a turbocharger onto a 1.4L Cruze or Encore ecotec engine, however, as others have mentioned time and time again...the studs are too long and need to be cut down a 1/4 inch otherwise you'll run into the problem I did and have to remove the entire assembly because it's impossible to torque down the turbo otherwise.

Very complete kit. Only issue is the manifold studs are a bit longer than the original. Also the copper nuts seem to “grab” the stud too early in the threading. I understand they are like that so tightening them drives the stud properly into head, but 1/2” of forcing the thread is too much. All worked out, but took a lot of patience and strength to get them all in and torqued properly. Suggestions for improvement - include a paper or card or something that describes what car/engine needs what gaskets/seals. It’s obviously a kit designed for multiple vehicles but I was not sure what gaskets/seals to use on my car. Ended up matching what I took off, but that assumes the previous person did it right. Deduct 2 stars for that, but otherwise it is a good kit.

The exhaust manifold studs are too long and you have to shorten them

The studs were to long so I used the original ones

Needed to replace exhaust manifold nuts, studs and clamps, so bought this kit. Be warned that the manifold studs in this kit will not work for a 2014 1.4L Cruze. The studs are too long and also have an unthreaded section that either prevents them from being installed far enough into the cylinder head in one orientation, or prevents the manifold nuts from being able to properly seat if studs are installed in the opposite orientation. I ended up cleaning and reusing the original studs. The rest of the parts in the kit that I did use seemed to work OK, but overall very disappointed. The attached pic shows the difference between the original studs and the studs included in the kit.