RackChoice 4U Rackmount Server Chassis 8bay 6Gbps Swappable SATA/SAS Drive Bays Include Sliding Rail and Minisas to SATA Cables

This is a great case for anyone looking to build a Plex Media server. I appreciate that it came with hot swappable fans. In my case, they required too much energy to run with my motherboard; however, you can remove them and use your own. Also, the rear I/O shield does not have easily removable plates. You have to remove them with a pair of pliers. Also, this will fit your over-sized graphics card with just enough head room for the power cables.

Solid server case. Highly recommend

I have this case. In the manual, it says that it is a SAS controller on the backplane. But, the supplied cables are SATA. I have a LSI SAS card, what do I need to get it working?

Overall I'd recommend and say it's a solid 4 star. There is no documentation. what you see in the picture is what you get. With that stated, the case is of solid construct. I got the suggested 20" rails too. What I like: -Solid and sturdy metal case -Top lid opens up by using 4 small screws and is sturdy -Plenty of bolts to spare -visually appealing -ATX Motherboard mounted fine -PSU mounted fine -Rails are sturdy and glide well -No screws needed for the hotswap trays. You angle in one side of the drive and then push in the other side to lock. - It has 8 Hotswap drives but also a mount bracket inside to mount a drive inside (OS maybe). Guessing you could also mount an internal cage. The hotswap drive backplane only needs 2 - 4 prong power. What made it rough to 5 star this -The fans are loud and sound like when you're in a jet cabin about to take off. They go about 3600rpm all the time and are rated for 5k. I tweaked the bios to slow them down, thus drop the noise. Ended up disconnecting one of the 3 until I can change this up. -The fan bracket has side slots to pass wires to the drives. Problem is it's a very narrow width. The ends of my power cables for the drives wouldn't pass through. You can unscrew the fan wall from the case, but kind of a pain. -There is nothing auto locking with the rails. I found the best way is to remove the 2 screws holding the front and back mounting plates with the feet. Then each foot plate, remove the little plates on the the ends that have 2 screws. 2 for front and 2 for pack. Then place the little plate in the front of your rack and place the longer foot on the other side and use the screws to screw them in. Once the front and back feet are in, you can screw back in the sliding part. -The hotswap trays are not durable. The lever could easily break so don't pry but wiggle and tease. When inserting the drive, I found if you kind of throw the drive in while sliding, it connects to where less pressure is placed on the arm. -The sata to minisas cables provided should be longer by 15cm. They barely made it to my board. Guessing other boards may have issues. They were also very rigid and not insulated like most I've seen. They do work as they recognized the 4 sata drives. -A little sad they didn't provide minisas cables and focused on sata drives. Waiting on cable to test sas drives. -Depending on your PSU, you may need extensions to reach the front pane. It seems the manufacturer is from china named daohe. Again, would recommend product as other chassis like this can be junk.

I’m extremely pleased with this case and wish it had been available before I purchased my Chebro and Internal Hard Drive Enclosures. It offers everything you would expect from a case like this: ample space, good ventilation, and excellent airflow. The only minor downside is that the disk trays can be a bit tricky to align with the slots, which might give the impression that they could break. Additionally, you need to ensure the front panel pins are correctly aligned for polarity. Other than that, no complaints!