Pyle PLA2200 1400W 2 Channel Bridgeable Mosfet Amplifier

Excellent great looking amp, works perfectly and pumps out volume just how I like it, LOUD! Very happy with this purchase

Not sure that the item should have silver screws and a photocopied manual???

It was ok not happy that when you purchase this amp that if you are not satisfied you can not return it

Was happy when received installed ok and after 2 weeks caused sub voice coil to fail. Ordered new pyle sub and same thing happened after 2 weeks changed to different make not had any problems.

I bought this for my first car, and first set up. I did the install by myself, with a little help from the internet, of course (as well as installing the stereo) without really any prior knowledge. Once I got the cables all run throughout my car, it was as simple as just plugging it in and turning on my stereo. It drives my two little 600 watt 8"s just fine and with no overheating. I accidentally blew a fuse by not paying attention and reversing the 12v power and ground... hehe. The only time it overheated and kicked into protect mode was when I parked in the sun and forgot to put up my reflector (it's in the back windshield, bolted into the metal of the chassis of the back seat) and it baked in the sun all day (it's black, so it gets monster hot with direct 98 degree sun). A little AC and shade and she cooled right off. tl;dr Great amp for the price, prompt delivery, easy install even though I had no idea what I was doing. Drives my 8"s just fine.

Works great. I have it on 2 10” subs. Way more power than needed.

I needed an affordable 2-channel amp for my setup, and this one delivers. The MOSFET design gives clear sound with decent bass response, and bridging the channels adds a good punch. It’s not the fanciest amp out there, but for the price point, it’s reliable and gets the job done. Just make sure you’ve got proper wiring for best results.

Great powerful amp, looks cool, sounds good, great value and price.

After I finally got around to having this amp installed, I was pleased as punch to having a little bass in my trunk. It sounded decent, for the price, and filled out the low end nicely. Unfortunately, the success was short-lived. After the first day (and literally less than 4 hours of use) the amp stopped working. I checked to see what had happened and the two 10-amp fuses on the amp were both blown. Perhaps I had the levels turned up too high, so I can claim responsibility for blowing the fuses (even though I'd think the built-in protection circuit would trip before the fuses blew - which it didn't). [Note: I'm using this amp with the Pyle 12" 600W sub, which you'd think would be a tested match]. So, I replaced the two fuses and expected to be back to normal. WRONG. Now when I turn on my radio with the volume on the lowest setting, the amp turns on for a second and then immediately goes into "protection mode" (the green light turns red). This means no sound from the amp. All of my other fuses are in-tact, but for some reason, the amp just won't stay out of protected mode. Given that it's broken so quickly, I'd say stay away.