DHA 28pcs Universal Press and Pull Sleeve Kit - Professional Bushing, Bearing, Seal Removal & Installation Tool Set - Suspension Bush Puller Kit with 20 Sleeves & 4 Spindles for Cars and LCVs

It worked exactly as it should for removing and refitting the bushes on my cars suspension.

Used the kit to replace the rubber suspension bushes on my discovery 1. Probably on the limit of the tool for the large ones but got the job done and saved hundreds. The smaller thread got bent at some point during use but for the price you can't complain.

Had to return this as was not man enough for large axle/subframe bushes, the problem is the steel threaded rods, its not good enough quality for very large bushes, it would have stripped the threads if I had of continued to tighten to get the bush moving, if you are doing smaller bushes probably 50mm or under it should be fine, its a shame as the kit is fairly comprehensive it just needs bit more money on better quality threaded rods and as always when using these really grease the rods up before each use and only use hand tools not power tools to tighten. I Had to return it as it would not of removed the large axle bushes without striping the threads.

I have tried to use it to replace rear axle bushing for VAUXHALL Zafira B, and the biggest sleve was still too small. Just to be aware if you intended to use it for the same purpose.

For the price this is a good set and is fine if used properly, if using these for really difficult bush removal I can imagine that they would wear quicker than the more expensive ones but for a one off job you can't go wrong

It's no good for removing the bushes however the tool snapped in 2 Putting them in on the other hand is a breeze absolutely in the park

I needed to change front bearings on our car, and went to the repair shop for a quote. They told me it will cost around £300 pounds per side, in case everything will go smooth and there are no complications. I had to watch quite a few videos on internet in order to understand how to use the tool. The tool was helpful and had all the parts needed in order to do the job. I'm very happy I had this tool and didn't have to pay the repair shop prices - I'll definitely keep it for next bearings replacement.

I am happy with the overall build quality of the sleeves and formers. I am unlikely to use the threaded pullers as I have a 12 tonne hydraulic bench press in my garage. These sleeves will be used as sleeves and mandrels on the press. The next job will be to uprate the bushes in the wishbone arms of a vehicle, a job I would not attempt in situ. The entire kit is quite expensive but it does contain just about every size you will ever need, and a hydraulic press is less useful without a set of decent sized tools to do the actual work SAFELY.

Jag har inte använt gängstängerna än men rörhylsorna fungerar bra till hydraulisk verkstadspress.