SLIDE HAMMER INSTRUCTIONS1.Clean damaged surface with a damp clean cloth.2.Slide one stick of glue into the glue gun and pre-heat hot glue gun for 5 minutes. (You can also use the lighter to heat hot glue.)3.Match the glue pad with the size of dent. Largest dents require the large pad.4.Apply a generous amount of hot glue from the hot glue gun on the selected pad covering the entire surface of the pad. Be sure all holes are covered.5.Immediately place pad in the center of the dent and hold until it sticks by itself.Let glue dry approximately 8 minutes. The glue should be firm.We recommend you do not let glue dry longer than 10 minutes.6.Use the slide hammer pull up the dent.7.Repeat process until dent is level with surface.8.After finishing the dent,use the alcohol and rubber shovel to clean the glue which on the car and the puller sets.Notice:1.The ideal temperature range to perform your dent removal is from 65-85 degrees F.2.If the temperature is cooler pull vehicle in garage where it is warmer or heat dent with a hair dryer.3.If the dent does not come up completely, repeat the process until you achieve desired results. (Note: not all dents 100% repairable)4.If the vehicle has cracked or chipped paint, applying glue and pulling the dent up may cause additional paint to come off.5.If the glue residue is left on the vehicle or pad you may use isopropyl alcohol to remove all glue.6.This product will work with excellent results on larger dents, however you will achieve the best results with smaller dent.You'll Get All This:Slide Hammer18 Glue Tabs5 Special AdhesivesRubber shovelComplete Instructions
Trustpilot
5 days ago
4 days ago
