Rug Renovator/Carpet Cleaning Brush

Great brush, worked well on my carpet with dry cleaning powder, saved my back. Only issue is the pole keeps coming loose, have to tighten it several times while using.

I absolutely love this carpet brush! It's sturdy, easy to grip, and does a fantastic job pulling up dirt, and getting rid of the stain. The bristles are firm enough to be effective without damaging the carpet fibers. I used it on some high-traffic areas and couldn't believe how much cleaner the carpet looked.

The Handle! The brush is sturdy and cleans up cat hairballs and other stains. WE have 3 hairy cats so you can only imagine the amount of hairballs that are vomited up daily. The BRUSH is awesome. The HANDLE IS NOT! The handle is cheap and I had to buy a sturdier handle. Thank goodness the handle I bought was under $10 so I am not too upset. It works perfectly now. I definitely recommend this, just know that the handle sucks.

We knew going into this purchase of this product that there may be an issue on the top pole sliding down suddenly when You are making a forward pushing motion on the carpet. This was based on the feedbacks many buyers had stated. The fix is shown (when completed) in the above first 3 photos. Make sure your pole length is where you want it, and hand tighten. A work bench is recommended....Not the kitchen table! I used a 9/64" drill bit as it was the size for the #10 (see Last photo) size screw x 3/4" long (#10 x 1/2" long will work also). You will need a hammer and center punch (or spike type nail) to put a small dimple into the upper pole approx. 7/8" above the junction of the lower pole.(measured from the black plastic flat ring at the bottom of the top pole junction.. The pole is a very hard steel, so your drill bit must be sharp or New in condition. Use eye protection. Start out with a pilot hole where you made your punch mark (indentation required) until you drill approx. a 1/4" deep. Next use your larger drill bit that is for your screw size. Drill your hole to 1/2" to 3/4" depth based on the screw length you are using....you will have black plastic from the core spiral out your drill bit...normal, as it's a solid plastic core inside this area. Install your screw using a #2 Phillips screwdriver by hand....a power drill is NOT a good idea for safety reasons when installing the screw. The internal Black plastic core will secure and hold the screw tightly in place.

You get what you pay for. Another reviewer had commented on the fact that the telescoping handle stopped working right away, and the same thing happened to me. I used some masking tape to keep it in place. It definitely is better than scrubbing the carpet by hand, which I had been doing. My carpet is fairly low, which helps with the cleaning. If the handle had worked, I would have rated this higher.

Love this brush, it works really well with the rug cleaning powder and really beats having to be on you hands and knees scrubbing. Its also easy to clean

This brush didn’t hold up the handle kept falling off. The brush works very good the handle kept breaking off so I couldn’t finish Scrubbing scrubbing my carpet. So I returned the brush

I have used this carpet brush for almost a year. I am so impressed with it. It is an excellent product! So easy to use and the long handle is a back saver! The two brush settings are an awesome feature. I highly recommend it!

Really good, nice rolling wheels, tough bristles. I bought this to scrub a rug (with running water, outside on my deck). I was pretty impressed. Took one star off because the top of the handle falls off, makes the rest of it look cheap.

Good product

used the brush on carpet where most tread occurs and achieved satisfactory result

As a professional carpet cleaner I love this product. Highly recommended

Should have read/believed the comments. First go handle doesn't stay locked in place. Second use handle snapped. $90 wasted. So disappointing