R290 Portable Air Conditioner Conditioning Unit 8000BTU 2300W Remote Class A

Well this thing is great and I only wish it had arrived one day earlier. Next heat wave, we'll be ready! It has been running all day and I'm pleased with the build quality. The design, I have some minor doubts about and I discuss those at the end. The operation is very simple. It's got a fan speed button (high/low) which controls the noise level. There is a set-temperature control which ranges between 32 °C and 16 °C. And there is a Mode control (Cool/Dry/Fan). I have only used Cool mode, and I've attached a diagram showing how cooling works. It's effortlessly chilled a bedroom room of about 25-30 Square metres, and I think it could manage a larger space. I like the Alecome ALC-PAC-8000 for three reasons: 1) The R290 is one of the best refrigerants. It is just propane, so nothing exotic or toxic. 2) The build quality is good, and 3) it includes the casement window interface. It is also easy to move from room to room. Moisture will be collected from the air as a part of the chilling process. The water is evaporated and ejected with the exhaust air instead of collected in a tank. The product description doesn't show it, but the device also comes with a water drain hose in case you have a place to dispose of water downward. There is a rubber stopper on the base that can be pulled, and the hose attached. If you were to do that, it would save a little further energy. The ductwork takes a little bit of setup and the device comes with two window interfaces. You expand and screw the 15cm diameter hose onto both of its end connectors. The small rectangle connector slides onto the exhaust port; and the large oval connector clips into the window frame interface board like a lego piece. If you have a sliding window, then you'd fill in the rectangular interface board into the gap, and you'd be done. If you have a window with a hinge opening on the other hand, like I do, then you have the crafty tent adapter. It doesn't look great but it does make a good air seal against the elements. I found the instructions a little confusing so I attached them here as a photo, as well as took a video. In short, you need to velcro the three non-hinged sides of the window and the three matching sides of the frame. You need to work out where to add the velcro so that you can still use the window handle and be able to open and close the window. Now I'll talk about my issues with this design. If you look to my diagram, you'll see there are two fan-driven airflows. The first airflow is room air across the chiller, and exhausted again as cool air - in my case around 11°C! My only issue with this airflow is the intake point, notice how I have my unit set up on the floor so that the exhaust hose climbs right past the intake? That means slightly warmer air is entering than true room air. I think that throws off the thermostat, and causes the unit to cool the room to colder than the set-point. If you were to set this up with the exhaust going away to the side, or down low, you wouldn't have this small problem. But in my mind, Design Flaw #1 is that the 36-37°C exhaust hose is not insulated, and so the longer it stretches within the interior space the more it re-radiates heat back into the cooled room. The second airflow is Design Flaw #2: ambient air is removed from the room, heated up and sent to the outside. This means that removed air needs to be replaced from somewhere. Warm exterior air will be sucked into the house to replace that air, and that's a moderate amount of energy wasted in my opinion. The third design flaw is also evident in the thermal image I've attached. Although the top half of the unit is cool, the bottom half of the unit is warm and also radiates a little heat from the sides. This is inherent in the fact that the compressor is kept indoors, the very space we are trying to cool. Design Flaw #3 is simply a consequence of having a single piece design. A mini-split design would put the compressor outside where it belongs, but of course that complicates the installation as you'd have to drill a hole and then also have the refrigerant added after making the connections. For Design Flaw #1, I'll plan to replace the 150mm hose with a self-insulated type. For Design Flaw #2, there is no solution, unless I'd want to fit a duct onto the lower front of the unit. I think I'd sooner have a mini-split installed. For Design Flaw #3, you could attach some foil bubble insulation around the two lower sides. Or, maybe it could be added to the inside of the plastic housing?

Cooling component broke with hours of use and company took a week to admit it was broken after they made me send a video and arrange collection and have yet to refund me 7 days after the collection.

Only had this a short time but it’s fantastic. Has cooled a small ish bedroom down from 25deg to 19deg in a matter of hours. Yes, it’s a bit noisy but no worse than a large fan. May even buy another for a separate room.

Stopped working after 4 days use. Waiting for seller to arrange return.

I Bought 2 of these, one for me and one for my daughters house. It cools fine but the noise levels are high and not easy to put up with. I was also disappointed that the fan doesn't oscillate, I just took it for granted that it would. Also I bought one in the morning for one price and by the I bought the next one in the afternoon the price had gone up by around 30 pounds. It was during the last very hot spell in the uk, I'm guessing it went up in price because of the demand . Not a tactic im a fan of ( no pun intended) I gave away the one my daughter didn't want after she heard how noisy mine was.

Great reduction of the room temperature but it is so noisy. also, some water leakage at the bottom even the water outlet is closed

Life saver in the heat. Are room is extremely hot in the summer. This unit cools the hole room. Window seal is fairly easy to put up. This unit is as noisy as a 20inch fan can wach tv with it on full speed with ease. I would rather listen to the fan at night and be cool than be sweating my bo**ocks off best £220 iv ever spent

Bought this unit recently with a view to staying cooler than last year after the temperature soared into 40. Tested it last weekend 20/06/23 when it hit 30, both my living room and kitchen stayed cool all day it was a joy!! It is no more noisy than air con in a Holiday hotel abroad and I slept comfortably with it on. The window vent curtain was a bit fiddly but got there in the end. Instructions are clear and the remote control is also good....Happy :-)