Fleece Performance Engineering FPE-CTDT-KIT Universal Cummins Turbo Drain Tube Kit (for 2nd Gen Swaps)

I'm sure it works perfect for the application it is designed for. Unfortunately It wasn't the application I was installing. But it was delivered on time. I just didn't order the right one. Lol. My bad.

If you replace the turbo this is the way to go

Product is ok but requires purchase of flange with 10 an fitting built in. Flange they sent requires you in install 10 an fitting into it to be used, problem is flange has wrong threads to do this. To install fitting would have to cross thread it in would not tighten up causing leak, only reason I kept this is the fitting that goes into block for turbo drain is hard to find alone.

High quality drain, too short for the upward position 2nd gen swap. Fixed that with a longer drain off the turbo!

I have tried to plumb several ways. I have shortened it. Clocked the turbo to create a straight shot to block, Clocked straight up and down. I have even tried 3 different turbos, and rebuilt 1 to try again. But I can not get it to stop pushing oil pass the exhaust oil seal. It isn't a ton of oil but enough to make a mess and have a blue haze while idling. I am very disappointed in this product. I wouldn't recommend anyone to purchase this.

The hose looks nice and the fittings are well made. The actual hose is only 18.5in long and comes up short for my application, a 4bt. The overall length is probably pretty close to 20in. If I had to do it over again I would get a cut to fit hose from the beginning. Unfortunately it's not worth the hassle of removing the fittings to return it.

This is just for show. I love fleece and think they are an outstanding company! So don’t let the rating mislead you, this is just a show hose for a stock turbo setup. If you have a second gen swap this will not work. Well at least with the stainless diesel manifold in the up position. I got a stainless line made for a little more at my local hydraulic shop that can actually with stand the heat.

I actually called Fleece P and asked if this would fit my 02 Cummins 5.9 and was told absolutely, well that's true...almost. It is about 2 inches to long, EXTREMELY difficult to get bent to connect up. It was either rubbing on the frame or too close to the A/C line and just not suitable. There are no instructions, QR code is provided but where it takes you has nothing about this, I had it on both ways with the offset end at top and bottom trying to make it fit, Instructions would have saved that part of my frustration. The product itself is of good quality and I have no complaints with that part. I was about to give up and have a hydraulic outfit try to remake it but I did finally got it on. It was frustration to the end though.