AUXITO 194 LED Light Bulb 6000K White 168 2825 W5W T10 Wedge 24-SMD 3014 Chipsets LED Replacement Light Kit Error Free for Car Interior Dome Map Door License Courtesy Dash Lights, Pack of 10

This is a plug and play replacements for the front, side marker lights on a 2004-2008 F150. They are bright and work great. If you read the fine print on the listing it says that it will not be able to fit the license plate lamps. I appreciate their disclosure. However, I was able to make them work. The issue is, the LED bulb is slightly too long. Perhaps by only a millimeter. I installed them regardless and held the wiring harness in there with some heavy duty duct tape. This solution is an entirely invisible, and it works perfectly.On the front marker lights they look slightly brighter than the stock halogen bulbs. On the license plate, they provide a very crisp, bright illumination. However, not so bright that they could be considered illegal.

1998 Ram 3500. Nice bright LEDs. They fit in my factory cab marker light receptacles perfectly. They are a bit longer than standard 194 incandescent bulbs. When reinstalling the silicone rubber OEM receptacles into the lens cover you have to be careful and insert it straight in or the longer LED will hit the lens cover causing it to lose contact. A little wipe of silicone lubricant on the OEM plug helps reinstalling the plug..

Works perfectly on parking lights for 2014 Mercedes Benz C300 4-matic W204. Compatible with CAN BUS. No dash messages post install. Very bright, and work well. I may pre-emptively replace the side-marker lights as well.

Strongly recommended, after installing and testing them.The narrative:My Gen2.5 Honda Pilot uses 194 bulbs in the corner marker lights that are integrated with the larger light housings. Part of the annual pre-winter inspect and service protocol is to check for failed bulbs. In my case, the two bulbs in the sides of the rear lamp assemblies had failed. I figured that all the bulbs came from the same time and had endured the same hours of service, so shopped carefully to find some decent LED replacements.These Auxito bulbs fit in the compact spaces in both the front and rear light assemblies. All the regular bulbs I removed had filament metal plated out on the glass envelopes, so were not very bright any more. These bright LED replacements are a very significant improvement to what are the only light sources visible from the side at night. So kind of important if you drive in the dark.I grabbed the 10-pack to upgrade several other places where 194 bulbs are used on the car. The inside door footwell bulbs are looking pretty tired. The rear HMSL needs at least two bulbs replaced too. I hope I have enough... :)One important thing to keep in mind is that these bulbs are polarity-sensitive, while the original bulbs were not. The sockets will accept the bulb base in either of two positions, but only one will actually light the LEDs. After you put the new bulb in the socket for the first time, remember to power that bulb on and make sure it's installed in the correct direction. It might need to be removed and rotated 180º before putting it back in the socket. By my observational math and probability analysis, While I had a 50% chance of getting any one in correctly on the first try, I had a 75% chance of getting each one wrong. Easy to correct if you do so before putting everything back in place on the car.I'm pleased with the installation ease, and with the good fit in the lamp housings. The light levels are great too. The light quality is enough better than the originals that you should plan on replacing all the old bulbs at the same time. The cost for the ten-pack is less than buying a card of four conventional bulbs at the local parts store. Not a tough value decision really.

I used these as replacement bulbs for my cab lights on my ram 3500. They were bright and easy to install. Good quality and looked great. However the lifespan being an L.E.D bulb was not that great. They lasted about 6 months. Good bang for your buck if you dont mind changing bulbs every 6 to 8 months.

light quality is great, snug fit in socket, profile size like original fit. Do not run hot like incandescent bulbs.

Works great , thank you

Really quick delivery and already installed more than half in the dash of my 1996 Peterbilt and what a difference. The old ones get hot 🔥 and these are bright and don't get hot.