80335 Muffler and Tailpipe Sealer, 3 oz., Plastic

Good product. Worked well as advertised.

Works good on seams that leak on a muffler. Used all of it. Not expected to be permanent but, works as a great improvement for muffler leaks. Less expensive than replacing a muffler.

The product itself is awesome. Seems anything I buy from Permatex does what it is supposed to do. For this particular "repair" I was a bit unsure as to which Permatex product to purchase. My motorcycle exhaust has a connection where the header pipe and tailpipe meet. An aftermarket "Jardine" exhaust and oddly quite a large gap at the connection whereas the bracket is supposed to crimp and does not do a very good job at sealing it. This may be how it was designed but for me an exhaust leak in your plan is not a good plan. Bottom line i wanted to seal this joint but wanted the option to take it apart to install new header gaskets down the line. Reaching out to Permatex they actually recommended a different product that was twice the cost of this with half the temp limit. I am happy I chose this as it sealed the joint and I was able to disconnect the pipes and install the gaskets. I am now looking to try a "lap joint" bracket as I would prefer a more permanent solution. I feel anything with the Permatex name is a good product but has limited shelf life and will eventually break down. The trouble is they make so many similar products it is hard to choose the correct one. In my opinion there is not one single best application for a particular project. Doing some research prior to buying is always recommended.

This product comes out as a thick paste, which fills gaps up to 1/8". Dries hard and slick. Does not do well with vibration, and cracks if the surfaces move against each other. That being said, this product stands up to exhaust heat very well, and as long as the surfaces are fixed, it will stay put. Be sure all grease and solvents are removed from the area to be sealed before applying. Good value !

I searched for a long time before deciding on this product to provide an extra seal to my exhausts catalytic converter flange. The flange in front of the cat was leaking, and so I r&r'd the old bolts, and then I wire wheeled the mating surfaces. Despite this, there was still a decent bit of pitting, and this 'sealant' worked well to fill in any imperfections that were present. I did this roughly 6 months ago, and daily drive the vehicle - no leaks from the area that was patched. I even reused the old 'donut' gasket since I didn't want to spend any extra money or time on this repair. I would recommend this to anyone who is working on an older vehicle with a rusty exhaust, or to anyone who wants to exercise an abundance of caution when trying to prevent any exhaust leaks following a repair.

This is decent for a temporary patch. Please don't expect this to hold up long term but for short term repairs this does the job. Over time it crumbles away.

Solid stuff that seals/dries hard and stays in place. Good for a bandaid fix and/or for ensuring tight leak free connection on a band clamp.

Had to repair a tailpipe and this stuff seems to be holding up well after almost 6 months.

tres bon produit

Great value

No cumple con la función de ser pegado y como vi algunos vídeos de YouTube decían que era bastante bueno pero como dicen en un vídeo y dicen en las instrucciones el sitio donde va la pasta tene que estar limpio pones está bastante limpio le pase un cepillo de púas de acero y luego puse agua y luego la pasta lo dejé secar 24h y luego puse en marcha el motor y en el escape se salió denuevo el agujero y un agujero pequeño aparte se hace como pompa parece chicle no lo recomiendo aparte no es soldadura en frío y no alcanza 2000 grados sino alcanza 110 grados y ya no sirve no lo recomiendo

Excelente sello sin problema la grietaxen ek escape...facil de utilizar

I recently purchased a product for my exhaust system, as there was some leakage around the joint. Despite following the instructions carefully, the paste came out within an hour of application. Additionally, after just two days, there's no sign of the product I previously applied. Based on my experience, I strongly advise "don't buy it"