Breakout Board Module with Pin Board for Teensy 4.1/3.5/3.6 Compatible with Arduino

Got it and had my new Teensy 4.1 mounted in about 15 minutes. It does take some soldering, of course but the pads solder easily. Disregard the comments about needing little red wires!! I think that photo is just showing that those pins are connected together. Each of the Teensy pin mounting points are directly connected to pin mounting points for the solder on screw terminals through runs on the board. No need for anything that's not in the kit - other than a Teensy, of course. As far as comments about the size of the terminal screws - yes, they are small, by necessity I'm sure. I have a jeweler's screwdriver set and and there are at least two screwdriver tips in it that fit the screw slots. If you don't have a set, get one!!

Prototyping Heaven with this one !! And overnight delivery..... Hell yes please !

Had to solder it together but expected that, had to solder the pins on the teensy so did both in 1 shot.

A previous review complained about the vendor not supplying the "Little Red Jumpers" as illustrated in the product page. That picture is somewhat misleading because where they show the jumpers there is a trace running between the two involved pads, all 48 pairs. The traces are a little difficult to see because of the black coating. Tilt the board a little under a light and they are easily seen. A quick check with a multimeter will also verify all 48 pairs are connected. As for the "tiny" screws on the green strips, just about any jewelers screwdriver set will have the 3/64" tip.

The first item shipped was not even the correct board. I ordered another one and while it arrived and will work, the product description should state outright that this does not come assembled as pictured. You have to solder it together yourself. I was trying to avoid soldering which is why I ordered this in the first place.

Awesome solution for teensy, the terminals are little to small but is good for the price.

First picture shows a fully assembled one but that's not how it comes and I have no desire to spend hours of my time soldering it up. Returned

The teensy in the photos is plugged in backwards! VIN is supposed to be next to the USB, not the SD card. When I plugged it in the way shown in this photo, my Teensy stopped blinking, and now it does not even communicate with my laptop at all, even without the breakout board connected. It turns out this is likely due to a design choice. The GND pins are tied together on the breakout board. This normally would be fine if the board is plugged in the right direction. But if you ever plug it in backwards and power it up, several of your GPIO pins will be shorted together, which as I have unfortunately shown, WILL DESTROY the teensy. Had they left all 40 pins isolated on the PCB, this would not have happened, and this danger would have been eliminated. I wish there were a way Treedix were able to replace my Arduino, because I was following their photo for how to plug it in.

Só me confundi na compra, pensei que vinha soldada.

Super