Sunnyglade ABS Plastic Dustproof Waterproof IP65 Junction Box Universal Durable Electrical Project Enclosure with Lock (6.7"x8.7"x4.3")

It feels like it will be watertight. It is good value, but clearly lower quality than some (expensive) boxes I've bought in the past. I was able to install some brass insets into the raised circles on the inside base of the unit, so didn't have to penetrate the box to install spacers for a control board I was housing inside.I did install some (Bud) vents at the top, and found the box material easy to drill and clean cutting.The cover has to be fought with a bit to close it. That may get easier over time, but at the cost of the tight seal I think I currently have. Time will tell.Good value for an economy project!

Needed a project box, went with this one because I'll need to open/close it pretty frequently, and didn't want to remove screws every time I needed to open/close it. Plastic handled being drilled, making cutouts, etc very well. No chips or cracking. Walls are thick enough to feel sturdy, but still work well with panel-mount components. Nice tight seal when latched. Reason I'm giving only 4 stars is because the latches and hinges. They are serviceable, but could be better.

Nice plastic box........Kidding it’s a great watertight box perfect for my application what is that application you may ask well let me tell you I currently have a leading home security system that has door locks with separate key pads. Well they are not water resistant by any means so I needed a box. This fit the bill in every way. So if you need a great little box for something that can’t get wet go for this one it’s great. Word of wisdom it’s not a design flaw but once you get it screwed in take it off and put a silicon sealer behind each hole to prevent a leak.

This box works very well for my application. I used it to install 2 exterior GFCI receptacles. The area in which they are installed receives a high amount of rainwater. This type of box should provide a higher level of protectiom for the 2 GFCI receptacles. When snapped closed the neoprene gasket should protect against any inclement weather conditions. We have had heavy rains since the installation, so far the box is weather tight. The factory supplied mounts for the interior box Mount and receptacles worked very well. The built-in standoffs on the back also made installation easier.

It does box like things. It opens, it closes. It opens, again. Then (wait for it!) it closes.Serious note: discolors in the sun pretty quickly. Of course it does - I discolor if left in the sun too long, too. But, if that matters to you (the box color, not the sunburn) do not leave it outside.