Shotgun Shell Holder - 12 Gauge Shell Holder / 10 Gauge / 20 Gauge - Match Savers with 3M Tape Made in Finland - Shotshell Holder Made of Heavy Duty P12 - Original Stage Saver by Rangenord

After trying to get an authentic Matchsaverz and not getting a reply for months, I went an purchased this. It does NOT come with mounting screws. The tape this came with was AWFUL and fell off - I prepped/cleaned the surface before initial installation. I used velcro and it is holding up well. Functions well, cheaper than the original, does it's job well.

This single shell holder was well made and the adhesive gives you a lot of options in where to mount it on your boom cannon.

This arrived early and appropriately packaged. Not a lot to it. It fits a 12 gage shell nicely. Comes with 2 screw holes and some double back tape to secure it. I can't imagine only using the tape. I'm using it on a pump slide, so can't fault it for not holding the shell tightly enough. After a few racks, the shell begins sliding off. I'll try adding a small strip of skateboard tape to see if that helps. After a few tries, it does make for a very quick reload.

Easy install. Works as it should. Seems rugged .

Shell slides all over the place when firing. Trying to think of something to line it with to grip better.

Very good quality holds shells tight. Exactly what I needed.

Works great, adhesive is very strong. I did put mine in the wrong position and had to remove it, and the adhesive came off cleanly.

Retention is horrible. The shell falls off after firing a couple shots of buckshot or slug. The tape mount seemed to hold pretty well even after 50 rounds of full power slugs though; assuming you applied the adhesive properly. You’ll see the emergency round fly off along with the spent shell on the 6th shot in the video.

Sehr gute Qualität, einfache Montage, hält was in der Beschreibung steht.

10” as advertised means 10 gauge. No option to choose a 12 gauge.