10 Feet of Blue and White Air Filter Media Roll , MERV6 Polyester Media - 25" Wide

I use this filtration media for a custom metal HVAC filter frame. I also rap this around the dry filter for my wet/dry vacuum. I've never had any problems with this filtration media. Pros: washable, reusable, durability, airflow, installation Cons: none thus far after years of use

We live in our RV full time. The basic filter is good for part time but these fit the bill when it comes to relying on your AC all the time. I cut these to fit the 4” round intakes and replace them with new ones about every 3-4 months. I need 8 in total so this roll has lasted me well over 2-1/2 years so far. They compress to fit my opening and you can obviously see how well they work. I ran my fiberscope through my vents and you can see the difference. Ours is a 2005 Newmar Dutch Star and I had both AC professionally cleaned a few years ago and they are easy to install.

works well for filter service, and i especially like supplied in a roll , which allows users to cut to size. A good money saver when bought by the roll, measures and cuts easily

This filter saved us a lot of money, it is washable, reusable, and does a great job for us! I would recommend this product and purchase it again, although I will not need to because of this reusable and washable!

Not much to say but it works great for my intended purpose which is cutting it up to the size needed to cover a pump intake. I can clean the filters when needed, and they seem to last about 6 weeks before needing replacing. They are good enough to where the water in the pond is crystal clear and that is what I like.

I’m running an assortment of Tetra HOB filters with the clam shell filter holders and go through EIGHT pads every two weeks. The cost of the tetra pads was killing me. I made a cardboard cut out for a template, and cut out all the filters I need for the change. There’s A LOT of media here for the money, and I think it filters better than the factory pads. If you lay your filter pads out just right you can get by with almost no wasted scrap pieces. With the clamshell holders I can double up if needed, or add bags of zeolite or carbon, or use infused pads. Really glad I switched to this.

Same stuff we use in the factory. I did a trial in my bathroom fans, for a few months, and they catch most all the dust that normally clings to the fan blades. I normally remove my fans every couple of years and totally clean all the blades with a Q tip. It's a long long job to say the least. This filter media will make my job less frequent but first I have to obtain some light weight plastic backing to hold the filter from being sucked up when it's clogging. My projected change out schedule is going to start at 6 months and I will adjust from there. This is something manufacturers will not endorse since most people will brain fart it and just fageddaboutit. But fans will only work well if you service them regularly. I'm down with home maintenance and we have scheduled maintenance for just about everything. If you aren't anal about maintenance don't do what I'm doing. As a last thought I'm going to be using this on my AC Condensing unit twice a year when the Cottonwoods are blowing all over, but this will mean daily checks.

I bought this to act as a filter around the bottom of my water heater. Before installing, I tested a piece with a lighter and, like most plastics, if took a while but finally melted and began to burn. Since it was going to be close to flames and if a rodent or something else pushed it under the heater, it could come into contact with the burner. I'll probably attach it to a metal screen and wrap that. Otherwise, a good bargain and I will be using it in more traditional applications.