MotoFabLifts CH-1R 1 in Rear Leveling lift kit that is compatible with Chevy Silverado Sierra GMC 2007-2018

Parfait fit impeccable 👌

This was the easiest install, I didn’t have to lift the truck or mess with the axle. I just took off the ubolts and lifted the leaf springs with a jack from the front side. Took off the spacer, put in the new one and dropped the leaf springs, one did not want to align, I just grabbed the tire and moved it and it fell in place. The other one I just dropped it and fell in place, no issues. Took me less than an hour to install. Just make sure you torque 74 ft/lbs

Went in fairly easy. Make sure you angle them big end back small end forward. I only had one jack stand and found that doing then one at a time, you have to jack up and down the axle to align the pins. I installed a 2.5 inch front level and the 1 inch over blocks sit my truck exactly where I want it. Haven't measured yet with these but with the front on it sat 1/2 nose high. These didnt make it exact level it's just a small tad rear high which is exactly where I want on my z71. All hardware was good and I did not have any vibration at all after install. Would definitely recommend.

U bolts were too wide to fit into the bottom plate so I had to bend them so they would fit. The nuts were just cheap and didn’t feel like the right size. Overall didn’t fit well. 2010 Sierra 1500

Easy to install if you know how to use a wrench. Lifted the rear of my truck one inch. A lift would be nice, but I just used Jack's in my garage and trust me you need a jack that has a long stroke, I was surprised at how high you have to jack up the truck