2 x 2.4GHz 6dBi Indoor Omni-Directional WiFi Antenna 802.11n/b/g RP-SMA Female Connector + 2 x 20cm/8" U.FL/IPEX to RP-SMA Pigtail Antenna WiFi Cable

Works great with the ESP32Cam I’m using it with, signal increased from a -51 to -38 in the next room over from the WiFi router.

As some other reviews have indicated, my Jandy iAquaLink 2.0 WiFi antenna deteriorated with the sun and weather and although I taped it up to make it last, I finally needed to find a replacement. Again, as others have indicated, a new Jandy iAquaLink 2.0 or Jandy iAquaLink 3.0 total unit replacement was ~$500.00. Following the advice of a few other reviews, I purchased the Highfine 2 x 2.4GHz 6dBi Omni-Directional WiFi Antenna as a Jandy iAquaLink 2.0 antenna replacement and it worked well. It was a quick replacement, albeit with a few extra steps, nothing major, but the unit was compatible and the WiFi is up and running after a WiFi configuration reset (Flip the WiFi switch when powered up on and off and then connect to the iAquaLink to re-establish your WiFi settings). A ~$9.00 antenna replacement versus a new $500.00 Jandy iAquaLink 2.0 controller.

Using this on an ESP32 connected to pool equipment outdoors in a cabinet. Since I started using this antenna the wifi signal has been spectacular.

Good quality for the money. The base is fixed and if you want to rotate it you have to loosen the screw and then rotate it. Otherwise it worked well for me.

iAqualink 2.0 repair: The original antenna failed due to sun exposure and it fell apart. It was suggested to me that we would need to have the unit replaced at $500 plus labor. After a quick search, I found that this antenna kit was a direct replacement of the damaged antenna.. 10 min of easy work, reconnecting the 2.0 to my wifi and the pool pump was up and running again! Since there are two, I now have a spare for the next time it happens. Great product, works exceptionally well with the Zodiac iAqualink 2.0 wifi interface.

I bought these for an ESP32 boards that support these antennas. Great range, very sturdy, and solid materials. Happy for the locking washers. I'm getting a great signal from 10ft, through an exterior wall. The cable length from the antenna to the board is perfect. Other than that, it looks great. I'll definitely be buying these again in the future.

I replaced the internal antenna in my engraver with this one. It connected with this antenna where the oem one didn't. The reception is great.

So my iAqualink 2.0 module is mounted on the west side of the house and after 5+ years the antenna was completely cracked and disintegrating. I found a reddit article on using this particular amazon antenna to replace it and really it was quite easy to do. I found that if you put the included nut and flat(ish) washer on the threaded end of the included cable it was the perfect length to go thru the module housing hole and rubber washer for the antenna to screw on and make connection with adequate sealing force on the rubber washer. YMMV but this worked out for me. Take care removing the little barrel connector off the WiFi module and installing the new one. These are easy to damage if you dont get them aligned correctly. Works better than before with much stronger connection.

Excelente producto, llegó en el tiempo previsto.

Good quality but the connectors weren't as shown but they worked for my project. I assumed I was receiving brass connectors as shown but instead got stainless steel! Hard to complain about stainless steel but if you are counting on brass with the removable RPSMA center pin, I did not receive that style.