200 Pairs 2.54mm 18-24awg Male and Female Pin Jumper Wire Cable Connectors

These pins were a good fit, I simply added a wire so I could connect a Meter or inject a signal. Worked fine and did not harm the connector.

They're okay but they tend to be a little short. Make sure the pin header your plugging them into is a little long.

Pins and socket inserts for Dupont style cables as used in Arduino, and other projects. So far all of them have worked perfectly. If you need it, get this one. It's good.

These are very short (10mm) and just barely fit in my crimper; there is no wiggle room and often get miss-crimped and destroyed. They are also made from a very soft metal. This makes them hard to remove from the strip they are attached to and also the wire is easily pulled out after crimping.

Not much to say about this simple product. Finally got around to needing to make a stepper motor to driver board connector and the 4-pin plug fit snugly.

Needed to make jumpers shorter/ longer than you can buy. Makes a neater breadboard layout resulting in easier debuging.

If you look at the picture of the product it gives a good representation of just how tangled up these are going to be when you get them. It appears to be end runs off of an assembly line, they are tangled and difficult to separate but they are usable after you get them apart. I haven't found any connectors that are damaged beyond use.

Work o.k. Not as stiff as what I am use to, making it hard to keep them in the crimper.