I'm using this stand daily, and I love it. LOVE. IT. It's incredibly useful - I've used it to hold my tablet, my ebook reader, and even my phone and laptop if I'm very, very careful with the positioning of them. This thing is very well made. Every part was machined to fit together nearly perfectly. I've put together a lot of furniture over the years, and this was by far the most solidly made product I've built. The instructions were also shockingly good. I've tested the fallover point of the stand; with my 12.9 inch iPad in it, it doesn't start to become a fallover risk until it's nearly at my eye level (I'm 5'5") with the arm fully extended in one direction. And even then, I have to exert pressure on it to make it tilt. To be clear, the stand will hold my device at any height, and I can trust that it won't fall over unless I interfere with it (push down on the end of the arm). If your use case will have this product at a much lower level and with the arm not at full extension, you can likely rely on it to remain upright even if someone or a pet knocks into it. The base of it is also wide enough that you could add additional weight to it if you wanted to. It's really easy to adjust the stand's position. I love how simple but sturdy the height locks are. The arm moves fluidly, and you can adjust the tension of its swivels with a coin, no special tools needed. The head of the stand is easy to open and close, and the lock is really solid and well-made. I would definitely buy this product again. I'm going to look for a book-holding head for it, too. I 100% recommend this product. It was worth every penny.
