HiLetgo Piezoelectric Sensor Analog Ceramic Vibration Sensor Module Piezoelectricity Piezoelectricity Electronic Building Blocks for Arduino DIY Kit

منتج سي لا يعمل كما ذكر في المواصفات

This is a 2 wire connection, not three as implied by the board picture/description.The board (+) is not connected.The board a 1M resistor between Signal and Gnd.The Zener has it's Cathode connected to Signal (S) and Anode connected to Gnd

I bought these for a drum light kit I'm building... and I read from the internet that piezos are capable of putting out a lot of voltage in spikes if hit hard enough, up to 90v! That's way more than the 5v that an arduino can handle.This is essentially a Zener diode with a 1Mohm resistor inline, so that if the voltage gets too much, the circuit will shut down instead of frying your stuff. So far they seem to be working well, even though my project has not yet come to fruition.

A good piezo vibration sensor that returns the intensity. In the video I have this sensor connected to an Arduino UNO with a RGB LED as the vibration indicator. The Arduino repeatedly reads the piezo sensor for a vibration greater than 0. If the vibration is intense enough, the current LED color intensity is altered to match that vibration intensity before moving to the next color. Otherwise the Arduino stays on the same color. I used a pollination wand as the vibration input. Also, connecting the sensor was simple enough.

It’s pretty much impossible to attach the very small piezo wires to that large connector. I ruined one connector trying to tighten it. Cannot tell if the device works.

Red hot garbage, the piezo sensor might be ok if taped to the side of a big bass drum but it could not be triggered by a vibrating phone. the tiny wires coming off the sensor are very difficult to connect to the terminal block as they are finer than frog hair. I was able to solder some thicker wires and that helped a bit.Overall this product is a fail from my experience.