EG Starts Arcade Diy Kit Part 2 X 8 Way Joystick + 16X Led Illuminated Push Button Player Coin Buttons for Raspberry Pi 3B Model Project Red & Blue

Der Lieferumfang: - Alles enthalten! - Zusätzlich noch eine Ersatz LED für jede Farbe - Zusätzlich zwei ersatz Microswitches Die Sticks: Optisch sehr ähnlich zu Sanwa JLF Sticks. Kommen mit einem Restriktor, der dem Sanwa GT-8F 4/8 Way Restrictor sehr ähnlich sieht. Das Sanwa Logo und eines von zwei >PC< embleme sind vorhanden, es fehlen aber das zweite >PC< und die Kennung 4. Die mechanischen Komponenten des Sticks sind gut geschmiert und laufen sauber. Die Feder ist stark eingestellt, kann durch Kürzen aber problemlos variiert werden. Die Triggerdistanz der Switches sind kurz, das Gefühl beim Spielen ist ordentlich und für Hobbyprügelspieler geeignet. Die Buttons: Coin, P1 und P2 logos sind bereits vorgeklebt. Die Verarbeitung ist durchweg gut, die Buttons wirken optisch hochwertig. Auch die Buttons haben eine starke Feder, die sich durch Kürzen anpassen lässt und haben einen etwas längeren Weg bis zum Triggerzeitpunkt. Buttons können Quitschen; mit etwas Schmiermittel vor dem Einbau aber kein Problem mehr. Gut geeignet für die meißten Arcade Spiele, weniger für 1on1 fighting games. 0-Delay PCBs: Die PCBs haben keinen spürbaren Eingabedelay.

Good components and the cables are saving me so much time

I bought this to upgrade my Mortal Kombat II Arcade 1up cabinet I just bought used to upgrade with a PC etc. Following the many videos on Youtube made it easy and this hardware works really well. Easy to install and cable. Everything works, only mapping the keys is trickier than it could be in my opinion, but doable. Lights all work. Interestingly not all the buttons are wired the same, so you may have to swap the Red and Black on a few. I found most were red cable to the red side, but some were the other way around. This is just to get the lights working, as they are LED and require the polarity to be correct. Very happy with the end result. Enough buttons to allow you to choose colours of buttons and I added a couple as suggested by Youtubers, and there are enough in this kit to allow you to do it. I had a small issue and contacted the seller through Amazon. They responded immediately with good solid advice which sorted my very small issue. Nice to get such a product and service from China.

Prodotto di buona qualità x chi si vuole cimentarsi come prima esperienza nella costruzione di un bar top

Simple install and plugged the USB into Raspberry Pi setup with RetroPi. Mocked it up on a cardboard box first to get the feel of how I wanted the buttons. 2 player kit came with all the parts shown plus some spare parts. Did not include hardware to mount the joystick or board to the wood. As shown in the seller’s photo about half the buttons had to reverse the wires to get them to light up. Weird, but a simple fix. A couple things that are not explained and I figured out with a little fiddling: 1. To take apart the buttons twist the switch about 1/8 turn counter-clockwise. If you want to change the image squeeze the white tabs to release the button then pop the top off. 2. The “Easy switch from 8-way to 4-way” on the joystick was not easy to figure out or do the first time. My video shows how. This one is loosened up a bit now, first time was stiff and tricky. Also note there is one position that will allow the center ring to fall out.