PAIR (2PCS) SUPER BLACK GLOSS Car Registration License Number Plate Surround Holder Frame Surround

These surrounds are built for clean plate presentation—high-gloss black finish with a clip-in design that holds UK standard plates tight. Geared toward cars, vans, or bikes where you want a stealthy upgrade without drilling or adhesive. Plastic’s rigid but lightweight, and the gloss coat gives a polished look without being over the top. Works well in daily drivers, show setups, or van mods. No branding, no chrome—just pure black that blends with trim or bodywork. Install’s quick: slide plate in, snap shut, and mount using existing screw holes. Holds firm, no rattle, and easy to swap plates if needed. Best paired with anti-theft screws if you’re running custom plates or want extra security. 👍 Pros ✅ Gloss black finish—clean, stealthy look ✅ Clip-in design—easy plate swap ✅ Standard UK fit—front & rear ready ✅ Lightweight but rigid—no flex or warp ✅ No branding—keeps it tidy 👎 Cons ❌ No screws included—use existing or upgrade ❌ Gloss finish shows fingerprints—wipe clean ❌ Not theft-proof—add security screws if needed

Bought these for my new Mercedes C300 when I transferred my chersished number as I had similar on my previous car, they avoid the unsightly screws that tarnish after a while. Easy to fit but needs a little care and patience to get the number plate to slide up into position. These are the black gloss type and look great on the car.

This is easy to fit and makes the number plate look a lot better especially 3d or 4d plates. Nice simple upgrade for any car.

My front number plate curves a little and I thought these wouldn't bend enough but they do. Easy to fit but sliding in the number plate into the holder was a little bit tight. Ended up tapping the number plate from the bottom with a rubber mallet. They look really nice and I'm well pleased with the finished look.

So glad I got these were easy to instal, feel secure on my car and also looks so nice since no screw holes in my plate. Screws provided and no use but still handy to have anyway.

At £20 these aren't cheap but the gloss finish looks good and they are relatively easy to fit. Screw the main body into place, carefully slide in the number plate into position and then the bottom edge needs to be clicked into place. Tuck the corners in and carefully line up the pegs on the plastic bottom edge trim piece with the holes in the main body of the number plate holder. Gently push together and you'll hear a click as it snaps together. DONT FORCE IT!! Make sure the pegs and holes line up before you try and click into place or you risk snapping off the peg(s).

Easy to fit and look really neat especially with 4D number plates. No more screw holes !!

My plates never seemed to be level and it was bothering me. Also, I get my car washed at various local places and they all use a combination of power washers and brushes/sponges, which over time has loosened the adhesion of the plates. So I opted to get a frame so I wouldn't worry about them falling off, which they have done at least once. The provided screws fitted perfectly into the manufacturer holes on the front and back of the car. Alignment wasn't a big deal, there are plenty of holes in the frame to get it fitted just right. I was a little worried about how much pressure the screw heads were placing on the plastic frame, so I used some washers to widen the grip on the frame, i'd recommend you do the same. Don't use a power screwdriver or a drill, tighten it by hand. After both were fitted they looked solid and in place, but in hindsight, they do add quite a large bezel around the license plate, but I can live with that. This is really the only reason I gave this 4 out of 5 stars, I was expecting the bezel to be a little thinner. That aside, apart from the ridiculous amount of packaging that Amazon boxed the plates in, everything else about the packaging was fine. Would recommend.

Nice

mooie qualiteit houders