Technoline TXCOVER Protective Case for Outdoor Sensors, Outdoor Transmitter, Thermal Hygrosensors, Weather Station with Outdoor Transmitter, White

Yes the latches to hold the base on are very poor. Mainly due to flex in the outer cover. I see some one suggested self tappers to lock it in place, but that didn't really work for me. However I used the lock end of cable ties. In this picture, the bit I used is circled in red. That is just for illustration. Two are needed. Just push one down each slot and it prevents the clasp from moving across the slot. The teeth on the cable tie resist movement. It works well. You just pull them out when you need to dismantle the shroud. Also it doesn't damage anything.

The base drops out of the housing. The latches are insufficient to hold the weight of the base and sensor. Had to resort to using a couple of self-tapping screw to keep the base from falling out.

A good enough cover for your outdoor sensor that provides shade & shelter but allows air to flow freely. It's easy to mount, with a detachable back plate that can be screwed securely into place and the main cover attaches firmly. The only problem is that the sensor sits on the base plate which hangs underneath and the two clips that hold it together are so small and flimsy that any movement in the cover dislodges the catches and drops everything on the floor. That's easily remedied by judicious application of duct tape or cable ties but it's not a neat solution to a problem that shouldn't occur

The base is supposed to lock in place by twisting but it's not very secure. It's fallen off several times and most recently has exposed the sensor to the rain - possibly destroying it. I'm trying to dry if out but it may be gone for good.

The slightest touch and the base falls out. I had to secure my sensor inside with cable ties then wrap cable ties around the whole thing to stop the base falling out. A good design very poorly made.

Biggest problem is getting it to stay together on the wall once the sensor was installed. I had to do a few modifcations to secure the clip that holds it all together.

Cumpre bem o que promete. Foi uma muito boa solução para proteger o sensor. x Does what it promises well. It was a very good solution to protect the sensor

The base does not lock on properly. I ended up using it by inserting a couple of screws in it to stop the flex. Junk- do not buy

Très bonne qualité. Protège bien le capteur des intempéries.

Goede kwaliteit, prima bescherming.

Come da aspettativa