A ABIGAIL Driving Fog Lights Lamps Replacement for Toyota Camry 2007 2008 2009 with H11 12V 55W Halogen Bulbs & Universal Switch and Wiring Kit (Clear Lens)

These went on an '09 Toyota Venza, I was slightly nervous just looking at these because of the differences in the housings but they fit great. I don't have high hopes for the life of the bulbs so I'll probably replace with LED before too long. VERY simple replacement process, and new lenses made a huge difference in the look! Love the price, and they arrived without damage.

Great product

I bought these for an 09 Camry. The install is simple. And they look great. It is clear these are used for multiple vehicles as the lens is larger than the opening of the front bumper. But after installation you cannot tell and looks factory. But my guess is that some of the light shines behind the bumper because of this (you likely won’t ever see it, but I guess it could get hot if not driving to cool it down). One thing this kit doesn’t have is a fuse tap. While you don’t need it, it makes it easier to connect the yellow ‘ACC’ wire to something. I chose a fuse circuit that only has power with the engine ‘on’ so the lights turn off when you shut off the engine so they are not accidentally left on and drain the battery.

Bad product, very cheap. Had to buy more wires and connectors and do the wiring again. Not recommended. Wish didn't open it so I cam return . Very disaponted

I purchased this product for a 2007 Camry LE. Installation was a little rough getting the wiring harness through the firewall, but I managed to get it through after cutting a small hole in grommet and using a coat hanger to pull wiring harness through. I routed the wiring from the plug underneath the coin tray through the firewall following factory wiring loom around the fuse/relay box in the engine compartment to the battery. Wiring is as follows: red wire straight to the battery; black wires (qty 2) to chassis ground; yellow wire (trigger wire to cigarette lighter wire (but any accessory 12V source will work that cuts off when ignition is off). And switch is in plug under coin tray. For this kit I purchased some extra black wire for ground and some loop connectors for wire ends. I soldered all wire ends and connections and placed heat shrink tubing over all exposed wire...even the red wire push connection going to fog lights with rubber cover. Bulbs in this kit are H11 so should be replaceable. Instructions are not that great which is why I am leaving this review with wiring connections that I used. Understand that these 12V/40A relays wear out over time and will need to be replaced. Plastic bezels snapped in flawlessly with no issue. On one foglight I had to open the hole a bit in the bumper, but that is because some plastic covered the hole a bit too much. Overall a good purchase, just know that some extra materials may be needed.