3 Gang Waterproof Marine Boat Rocker Switch Aluminum Panel, DC 12V/24V 5 Pin ON-Off Switch, with Upgrade Arc LED Digital Display Voltmeter and 4.8A Dual USB Slot Socket for Boat Car Rv Vehicles Truck

Put them on my boat fuse box and hooked up the fish finder and boat lights to it and it's perfect for being able to just flip the switch when I want to use either of them.... highly recommend

What can I say. It's not 1 switch, but 3! I can turn on and off random, umm, "things"! Now I am the coolest guy on the block because I have this thing!

This product is great for adding more switches to our boat. But the only thing I wish it came with was a template for cutting out a hole for them the go in. Highly recommended but be prepared to make your own template for cutting.

I installed this switch bank on the side of the rear compartment on my Tracker Party Deck boat. I had used all the switches available on the console, and added auxiliary fuel and bilge pumps and needed switches for them. I will use the third one for more lighting at the rear of the boat. I can just reach back from my captains chair to turn on the fuel pump when needed, and mounted the switches in the box to avoid bumping them when going to the back swim deck. I looked for basic 3 gang switches, and decided on this one with the volt meter and the USB charging ports on it, and was glad I did... it has worked out great! The lighted switches are nice for night rides, the charging ports are great for phones and spot lights, and the meter is always on (when the batteries are engaged), so I can see the voltage at a glance without opening the compartment to look at the charger, or turning on the key on the console. My 3-bank battery charger was in "Condition" mode when I snapped this picture, which explains the higher voltage reading... it usually runs around 12.7 volts. I have used other lighted single gang rocker switches from this manufacturer, and they have all work great.

I would of given 5 stars except there is no template included for the cutout. The retaining nuts are in the path of just cutting a square. You have to cutout for nuts and this leaves just a small piece left for the screws to mount. Just not an easy task which a template would really make much easier. As far as fuction and looks, it's great.

We have power for the bilge and for the trolling motor. Works as advertised.

Looks like it's built good. Rocker lights just a bit bright for SXS night driving but easily covered with black tape. Decent value. Wiring is much better than expected. Black tape is already on the large led portion of the rockers.

Voltage meter dead on arrival bought another to replace