M-D Building Products, Gray 04267 M-D Epdm Adhesive Weather-Strip, 1/4 in W X 17 Ft L X 7/32 in H, 1 Pack

I have some old wooden windows installed in the 90s that have a solid plastic weatherstripping which is brittle and has broken. I replaced them with this 7/32" weatherstripping. It's the perfect size, sticks well, and has enough give to seal but still allow the window to close tightly.

I replaced a decades-old pile seal around a screen door. Since I couldn't feed it back through the channel without disassembling the frame, I used the adhesive instead. To my surprise, it's incredibly strong—even after applying it on a humid day, and with a week of hot and humid weather since, it's still holding perfectly. The door works much better now, as the old seal was completely flattened from age, and the new one looks great!

The adhesion was better than the ones at home improvement store and the store didn't even have this size which is the size I needed. Fit is perfect for single pane mobile home windows

Perfect replacement for the seals on my litter robot.

I changed the weatherstripping out of a couple particularly drafty windows and it was fairly easy to do and sealed the gaps, but the windows leak around the frames. And, that is a much bigger problem. So, changing out the weatherstripping did help, there's only so much you can expect when the actual window installation needs to be upgraded

I bought this product because it was the right width for my project. I used it to isolate two very large sliding doors in a high rise. It was easy to stick to the doors and frames. The only issue I had was that some 20 inches did not have any glue at all.

Product does the job of blocking drafts really well. Hard to find at local hardware stores. But sections of the adhesive strip just wouldn't adhere to aluminum. I had to glue them down. Still recommend as it does the job.

I looked for this product at all the hardware stores around town (Lowes, Home Depot, Walmart, Target, etc) before I found this online at Amazon. It provides a good wind and dust seal for my sliding windows and it's super-easy to install. It's literally: a) measure; b) cut to size; c) remove backing tape and d) stick to surface. To get the best adhesion, I thoroughly clean the surface of the window and then alcohol the area to be sure all finger oils and dust is gone before I apply the weather-stripping. I think it sticks longer this way. Overall, good product. Would buy again in the future.

Que bueno encontrar este tipo de productos por este medio ya que solo lo había conseguido en el extranjero

Does not stick!