Wilton 14831 A-6, Aluminum Jaw Cap, 6-Inch Jaw Width, 2 -Pack

SAVE YOUR MONEY. The magnetic strip that replaces the round pressed on magnets DOES NOT stay GLUED into to channel. The magnetic strip CONSTANTLY comes out of the channel and will not squarely tighten up in the vise jaws. JUNK! CONTACTED WILTON and they said , well that's just the way it is. These were MADE IN china! THE ones that are well made, are made in Sweden.

Nice looking but they have a fatal flaw that makes them pretty much useless, at least for me. They stand too tall above the top of the vice jaw, so if you try to grab something short, the jaw pad pops out of place and ejects your part upward. See photo. Most of these aluminum jaw pads have a very thin section that sits on top of the jaw so this tilting problem is much less likely to occur. They are also very expensive compared to alternates.

They stay in place perfectly when you’re working with the vise.

These are fantastic. I was afraid that they would slip out of my vise because i have flat faced jaws but they are holding tight.

Gotta have these