Gates K070610 Micro V Serpentine Drive Belt | Replaces 7K610 90916A2019 99367C1550 99367K1550 610K7 5070610 7PVK1550 5070610DR 7K1549 4070609 609K7MK 7K610AP 7PK1545.

Highlander 2008 limited 3.5L 190.000m Excellent la misma de autozone

great quality procuct, fits perfectly

A good replacement for my 2010 Lexus GS350 AWD with the 3.5L V6. It went right on, and after 500 miles it sounds great and works perfectly.

Direct fit for 2011 Highlander V6 base 2WD model. Was replacing alternator (which requires removing radiator) and found the original was clogged beyond belief plus had a small leak discovered once removed. New upper, lower, and 2 transmission cooler hoses from Toyota (32943-48111 and 32943-48151). Decided to also replace serpentine belt and idler pulley while I had it off. Make sure you have the belt routing drawn out before taking it off. Given the tight fit (needing to turn it sideways to get between the pulley and inner fender, hoses, etc.), I enlisted my daughter with smaller hands to help reach thru wheel well to help route as I moved the idler pulley and got belt on from top. Everything should go for many more years. 9/9/2023 - Perfect fit for our 2010 Lexus RX350

Serpentine belt seemed to be made with good quality. This size worked well on my 2008 Toyota Highlander. There are videos online that explain how to change the belt. Took about 20 minutes to change. I included a picture comparing the belts. The belt on the left is the original serpentine belt with 135,000 miles on it. Probably could have got another 30,000 miles out of it, but why risk it. The belt on the right is the new one. For the price, it is well worth it.

I noticed a Dayco belt with 30,000 miles on it developing a tear in the center of the belt. The 2011 Sienna, 6 cylinder required removal of the passenger side tire and plastic access panel to access the belt from underneath. A 14mm wrench was needed to turn the tensioner until a short 5mm hex wrench or bolt could be inserted to relieve the belt tension. Make some notes or take photos of your belt routing before removing your old belt--many belts can be misrouted. Feed the new belt from underneath--there isn't much room. Slightly turn the tensioner and remove the 5mm tool. Check that the belt ribs are all within the pulley edges. Bump the ignition a few times but don't start the car. Look at the belt routing again to confirm correct install. Shop book time for this job is 0.7hrs. If your car doesn't have a transverse mounted engine then your replacement will likely be much faster.

Pretty good belt for now, fits the 2010 highlander V6. Always check with original/old belt first. Its a little thinner than original belt.

Works just as advertised. Would buy it again and suggest friends do the same.

Right size, Quiet.

175k on original belt for 2015 Toyota Sienna. It just recently started to make a slight squeal on cold start so I decide to replace it with this Gates belt. Fits just like the original and easy to change.

Fit my 2008 IS250 AWD

Fits as it should, works as it should

good quality, good price