POWERTEC 71391 Table Saw Precision Miter Gauge System 24” x 3” Multi –Track Fence with 27 Angle Stops

This is a quality product at a reasonable price

Took 5 minutes to assemble and 20 minutes to square up. It was a degree + out of square. Simple matter of loosening the four 3mm screws holding the fence backing to the gauge itself. Set the gauge at 0* and use a good square to line up the edge of the blade and the fence. Once satisfied, hold the fence down tight and carefully tighten the screws back down. Check again and repeat if needed. Once the 90* was set, the 45, 22,5 were dead on. Of course get your three slot disks adjusted for your slot so it slides freely with no side play first, then square the fence last. The allen wrenches they send are soft and the screws for the fence were tight. I could feel the first head starting to deform so I threw those out and used a metric set of Bondhus 2mm and 3mm wrenches. Much better fit. After far too many test cuts I am impressed with the accuracy and repeatability of this miter gauge. The included flip stop is solid with no deflection also. Good bang for the buck here. Using machinists squares and I can't see a $400 gauge getting any tighter joints than this gives you once it's set up. It's a keeper.

PARFAIT

Cuando se cambia de ángulo no es fácil volver a los 90 grados, resulta tardado realizar los ajustes

Better than I expected. Once I zeroed out the miter, it is dead on and repeatable at 90 degrees. That is all I tested. Very sturdy, easy assembly and setup, did not have to look at the directions. Love the fence and the graduations. The stop is stiff enough for real use. the adjustment for the slide works very well. I would buy it again if I needed one.The small parts sled is also better than expected. It is 90 degrees as best I could measure with a good framing square. No adjustments needed. Nice fit and finish. The only thing that could be better is the adjustments on the slide bar are nylon set screws from the side that are tedious to adjust and move with use. Need to add some Loctite or something I suppose. Great value and saved a lot of time instead of designing and building one from scratch. Feels very safe now to make small wood pieces.