Full Motion Dual Monitor Free-Standing Desk Stand VESA Mount with Articulating Double Center Arm Joint | Holds Two 13" to 30" Screens (STAND-V102F)

Does exactly what it says. It can easily hold my two 27" monitors.

Es un buen producto, cumple con las descripciones y está muy bien ...

I purchased two Acer K272HUL monitors and the included stands were at a set height. Because of my desk that has a steel bar that runs along each side underneath, getting a dual monitor stand that mounts to the desk with a clamp was not an option. This is a great alternative and really cleans up your desk space. The clamps for cable management are great too. If anyone has any doubts about the stability of the stand with two 27" monitors, any instability is only due to the fact that the arms need to be folded in a 'W' shape, not a double arc. If you attempt to keep the arms in a double arc and set the stand upright with the two monitors, the stand will easily tip over. Once I folded the arms in a 'W' shape, the stand was perfectly stable and has withstood my adjustments to the positioning and angles of the monitors without any concern of tipping over. Overall the quality of the hardware feels really good too. I would definitely not hesitate to use it on a more expensive monitor setup if I were to upgrade in the future. Just be very careful if you decide to set the monitors back down on a flat surface while mounted to the stand, as the arms will swing together and cause your monitors to collide. I had quite a scare when it happened earlier, but fortunately no damage was done.Edit: Not going to change my review, but one thing that is extremely annoying and a fail on the part of the engineer(s) is that the bolt for the adjustment for forward and rear tilt on the left arm is on the inside of the arm. Having to reach over the arm of the stand and the monitor both simultaneously to tighten and loosen the bolt that enables the monitor to tilt forward or backward is extremely troublesome. On the right arm this is not an issue, because the bolt head is on the outside so you simply can reach around the side to tighten or loosen the bolt. Being a mechanic, I fortunately have the tools. I was able to use a long handle ratchet with a hex socket to tighten/loosen the bolt on the left arm. I really do not feel like the included hex tool is adequate for this adjustment and you will be cursing the engineer(s) in no time if you try to get the monitor to sit level without a good ratchet and hex socket. I would also strongly suggest you have a small plastic level to check the monitors as you make your adjustments to get the monitor to sit level, because the bolt has to be very tight and will have a tendency to droop slightly if it is not tightened adequately. If I had to guess, I'd say I used approximately 30 to 40 ft-lbs of torque on the bolts that control the monitors ability to tilt.

Fuss free setup. Only issues I had was the tightening of the centralised spine. I had to use a lot of force to tighten it as the extra weight from the monitor is pulling it down

Item received in good condition and works well. Able to support 2 24inch monitors without toppling over.