17in1 full face Cover Protective Respirator Rubber 360° Full Seal Protection (Respirator +Canister) Widely Used in Organic Gas

It does not have a manual so I had to recall product pictures to assemble correctly the mask filter. Intuitive use. Full face coverage. Seems resistant. A bit heavy but manageable. A little difficult for breathing at first but with time you get the rhythm. Comes with 12 filters, you will need two, so there are extra 10 or 5 extra pairs.

Works great. Comfortable and easy to adjust and breathe for maximum comfort.

I wore this mask under a house riddled with mouse excrement and smelt nothing, I am an average sized guy and this mask is a wee bit small

Couldn't do the job without it.

Don't waste your money on this respirator. The cartridge filters do not filter out contaminants as advertised, particularly shop based chemicals and solvents. When filling or working with engine coolant, washer fluid, and oils; I can still smell these contaminants through the masks dual cartridge filter setup. The filters are also highly prone to failure, being affixed to the mask via snap-in setup. This means that while working, if you bump the filter against something; the entire canister filter will disconnect and open the mask to the surrounding environment. To reattach a disconnected filter, you have to remove the mask, reach inside of it, and manually reattach the filter to an o-ring inside of the silicone facial fitting. The mask also does not have a voice diaphragm as advertised, and highly restricts the wearers ability to talk or communicate while wearing. Highly unsafe, and gives the wearer a false sense of security against toxic contaminants and/or COVID infection risk.

Great for epoxy!

Not safe to wear - inadequate airflow, poor seal. I don't like 1-star comments, but this item is actually hazardous to use. The airflow through the filters is inadequate for breathing. I tried on the mask without the filters attached and noticed that the shape of the mask was clearly made for a rounder asian style face, not my oval white face. By tightening the straps, I could get a seal - but only by getting it so tight it hurt to wear. I had to take long deep breaths to get any air into the mask (with or without the filters on). That should have been the final red flag, but after about half and hour of usage, getting progressively worse, I was genuinely concerned I would pass out before I could get to a safe location to remove the mask. Thankfully I managed to get out and was panting like I ran a marathon.

Product was not abused. Please send replacement frame.