Galaxy AutoGalaxy Auto Gloss Black Hot & Cold Side Intercooler Pipe & Boot Kit Compatible with 2011-2016 Ford 6.7 Powerstroke Diesel 6.7L Superduty

I purchased this just for the cold side IC tube replacement after my OEM tube burst. I figured if this went well then I would do the hot side later...First of all, it comes without any instructions at all. While it isn’t overly difficult to piece together to figure out, it is very tricky to get it into the spot and connected. Instructions for assembly order would be a huge time and hassle saver. It took me a few attempts before I decided to install the IC elbow first, then the rest as an assembly. Ok, not a huge deal.However, most of the spring clamps will NOT fit. You’ll need to remove the springs to make many of the clamps fit - which entirely defeats the purpose of spring clamps advertised as “constant pressure clamps”.The worst part is that the friggin thing doesn’t seal!!! Not completely, anyway. The fitting that attaches to the intake inlet with the o-ring and wire clip doesn’t seal completely. When driving, any boost over about 10lbs will squeal - loudly. It sounds like air escaping out of a balloon. I’ve messed with it a couple times and I cannot get it to fit any farther or any better. The locking clip is fully engaged in the dame place it is used on the ORM setup. I haven’t attempted to contact the seller yet as it’s drivable, just annoying as hell. Not to mention, if it’s leaking it’s hard to tell how much efficiency is being lost.I’ll update if I make contact with the seller. Otherwise I’ll eventually replace with an OE replacement and either try to return this or toss it.Maybe it’s supposed to fit further on??? I guess instructions would’ve told me that...

Worked well on my 2014 F250. The paint scratches very easily, but I wasn’t concerned since mine isn’t a show truck and it is aluminum underneath. No instructions were in my box, but it didn’t require much to figure it out.

Pretty easy to install once you figure out where everything goes. Have a small boost leak now that I can't locate but it's not that big of a deal right now, the stock part blew up as most will.

The kit popped off twice. The clamps given in this kit are not enough to hold the kit on my husband had to double clamp top.

Like the other reviews said, the clamps are to small. I had to leave the tension spring off to get the clamp back on. It was missing the O ring for the hot side. Sent it back.

Easy to install, best bang for buck

Hot side didn't fit correctly cold side good

Only one hose fit, the other was a difficulty puzzle. Returned it for OEM part from dealer.