Indian Motorcycle Oil Change Kit for All 60 & 69 Cu In Liquid-Cooled Scout Engines, 4 Quarts 15W-60 Full Synthetic Oil, 1 Oil Filter, 2 Washers, Clutch Performance, Engine Protection - 2880191

I have a victory octane and if I use any other oil it doesn't shift right. It's a bit pricey but you get good oil, a filter and 2 crush washers. FYI if you have an octane or scout, they have 2 drain plugs. Make sure you pull both out.

I have a 2022 Indian Scout (and am a motorcycle shop owner for more than 40 years). I recommend using factory-designated parts and fluids if they are competitively priced, and frankly, I prefer to just make one uniform purchase for everything I need to do oil service. Factory oil viscosity makes finding alternatives a bit of a challenge anyway, so get this (and change oil at least every 6K! (the factory 10K service is a very bad idea, likely encouraged by EPS.enviroment... not motor manufacturers.

Includes everythjng that is necessary to service my bike

If you think that a washer is missing, check under the flap of the box. Everything was as promoted. I did get a inexpensive funnel so it was easy to put in the new oil.

Came with everything you need for the oil change! Fast shipping too thank you so much!

Everything is good. Look close for the washers. Like in between the oil containers.

First off, complaining about the price is just not being realistic. It's not any cheaper to put out the effort of sourcing compatible oil and filer plus the crush washers. Second, for most riders it is a once a year job. Are you going to go through the pain of sourcing similar products individually for a probably less than $10 savings once a year? Not me. Another reviewer suggested making sure the drain bolts are very tight. NO. Too many people have stripped the engine case threads doing that (nightmare). Indian calls for 15 ft lb torque on those bolts which is too high. That's dry torque. These bolts are not dry when you change the oil. That requires LESS torque. Remember you are using new crush washers each change. That allows you to just snug them up. I don't normally use a torque wrench on them but I did to see what the actual ft lbs I been using for years was. With new crush washers 10-12 lbs will work fine & they won't leak. And you won't have $$$ repairs for stripped threads.

Everything you need in one box.