Capricorn Bowden PTFE Tubing XS Series 1 Meter for 1.75mm Filament (Genuine Capricorn Tubing)

A oesar que lo reemplace el de fabicra de mi Ender 3 Max, aun estando en buenas condiciones, ha mwjorado mucho el recorrido del filamento, ya que he probado algunos de marcar no tan conocidas sin ningún problema... Altamente recomendable para sus impresoras 3D, un Upgrade mas que necesario.

I have purchased three capricorn xs tubes already, the initial experience was unsatisfying and full of self errors, the bowden tube I cut was not cut straight and my filament also needed to be cut, once that was resolved I printed petg on two different types of machines, one with a through hole 1.75mm heatbreak so the tube was directly on the nozzle and one with a capricorn ptfe liner 1.75mm as well. The retraction and temperature consistency was different and certain artifacts dissappeared from my prints such as ghosting and some retraction lines and blobs, I strictly print petg filament right now and am satisfied with the finish, please take note of a couple of extra steps that need to be taken to avoid jams and pressure on the push fittings; 1) always make sure your cut is straight and clean, 2) double check filament tip if inserting different roll of filament as it can cause back pressure that may ruin certain push fittings and cause them to stop working. There are some precautions with filament changing though but they are no big deal, no cold pulls or the filament may get stuck in the ptfe tube so pull it while its hot and clean up the tip. I will definetely buy again.

If you are doing a lot of printing, a nice bowden PTFE tube is a must to have.

I run 4, 3D printers, first thing I do when I buy one is replace original bowden with Capricorn bowden. Tolerances are spot on and it is VERY long lasting. Can strongly recommend.

Best stuff on the market was replacing the crappy white stuff on printer