MaxxHaul 50025 Hitch Mount 2-Bike Rack for Cars, Trucks, SUVs, Minivans – Fits 1-1/4" & 2" Hitch Receivers, 100 lb Capacity, Anti-Rattle, Secure Cradles, Heavy-Duty Steel Construction - Color May Vary

It's the cheapest bike rake I've seen anywhere and it holds two bikes. There is just a smidgen of play when connected to the tow hitch but it's minimal and is perfectly fine. It's not going anywhere. Easy installation (though the wrench they include is useless as it is larger than the included bolts and hex nuts. You need a 17mm wrench or socket to install. Preferably both. One to hold the bolt, the other to tighten the nut. I'm heading to the West Virginia mountains in a couple of weeks and look forward to strapping my bike onto this bad boy.

Move two adult bikes with no issues with this bike rack. It’s super sturdy and doesn’t wobble, even at highway speeds.

I purchased this bike rack due to the number of high ratings and price point. Overall, it seems like a good value. However, when the package was received, the box had some torn areas that were covered with clear packaging tape. So, I suspected that the box was damaged somewhere between the manufacturer and my front door, and there was likely one or several parts missing. When I opened the box and inventoried everything against the install guide, I was correct. It was missing a lock nut and two washers. I knew the local hardware store would have these in stock, so i made a quick trip there in order to get the assembly done quickly. I didn't want to go through the hassle/time of boxing it back up and returning it to Amazon. Once I had all the parts, the bike rack was easy enough to assemble. It was also easy to install in the 2 inch receiver on the back of our SUV. Instead of the normal hitch pin, it uses a special bolt that threads into the receiver portion of the bike rack. The end of that bolt is unthreaded and narrow, so when the bolt , washer and lock washer are tightened on the head end, the opposite end portrudes through so you can insert a pin clip (provided) into it as a safety measure. Also, one nice design feature is that you can pull a pin and tilt the rack forward, which allows you to open the rear hatch without completly removing the bike rack. After I installed it on the SUV, I did some tugging on it to see how sturdy it felt. For my needs, I think it will be more than adequate. We are just using it to get 2 bikes up to the lake (about 1.5 hours away), and also to local parks where we can access the bike trails. Again, my only complaint about it, so far, is regarding the few missing parts. I think the manufacturer could devise a way to ensure the small parts don't get lost if the box is damaged in transit. I will expand my review with "actual use" comments once we've taken it somewhere.

Got this for my son to be able to take his bike on vacation! Did very well in the drive! No knocking, no damage to paint and very easy to install! For perfectly with my SUV!

OK, I have read a number of negative reviews about the MAXXHaul Bike bitch Mount 50025 complaining that the rack wobbles or the bikes wobble somewhat while driving. I have been using this bike rack for 6 months now and quickly learned that the hitch mount locking screw needs to be tightened down using a ratchet wrench, not the flimsy wrench provided with the rack. This will help ensure that the rack is completely stable in the 2" hitch, (which, by the way, fits perfectly in my Lincoln Navigator 2" trailer hitch). Regarding bike wobble, this is easily overcome with the use of bungie cords around the rack center post and bike frame, and Velcro tie-down straps to stabilize each of the wheels. This takes very little effort and minimal additional expense to ensure that your bikes are mounted securely and safely. If you wish to be doubly secure, you can also attach a Rhino USA Hitch Tightener which will provide an extra level of security against any possible wobble of the mount in the 2" trailer hitch receiver. This tightener is also available on Amazon. Overall, I am very pleased with the quality and utility of this very attractive and well built bike rack. I have used in on both local roads and at highway speeds and i am completely satisfied with this purchase. I recommend it highly!

Poor design. Part wobbles in hitch. They tried two patches. One is to screw down thin shims in the plastic block that goes into the hitch. The screws they send are to small to bite into anything on the plastic block. So the sims will not stay. The other is a bracket (clamp) that goes over the hitch which requires wrenches everytime you want to remove the bike rack. I have had other brands that I had no issues with. These patches look like an after thaught.

Excellent, easy to set up and use

Didn't fit my class 1 receiver had to cut a little bit of it off. Also the plastic square that covers the top came in broken. Might modify it later because if the screws for the end caps fall off the bike could fall off. I will probably end up using cotter pins

Great piece of kit easy assembly and solid when on the towbar.

Easy to install, l got small issue for my bike because its xs frame size, but it can be manage somehow, overall its great handle and worth for offered price, Thank you.

Great lighter weight unit. Easy to attach and remove. Very happy.

I wanted to wait until I had to use this a few times before I pass judgment, but I have to say wow I found it simple to put together the rack looks to be well made, I have a Ford Escape that I've had to take it off and put on different times for road trips and I found it quite easy to put on and remove and I love that it has a lever that you can lower the bar so you can still open up the hatch without having to affect anything. Just the way the bikes hang they do bounce a little bit but I found no reason to be concerned about them tied to the back. I have also taken it off roading with quite rough roads and have held up really well.

Great