BETAZOOER Reptile Humidifier Mister Fogger Extension Amphibians Snake 2.5L

tl;dr No issues after 20 months of use. This unit works quietly, creates plenty of fog, and I've had no leaks. The dial allows me to tune how much I want to fog up my vivarium and the higher end pushes enough for a dual tube system. Its a constant on when the dial is turned so a timer or thermostat is needed, but once it's set up, it just needs refilling and general maintenance. If you live somewhere, like me, with hard water; use filtered water and clean the base out every once in a while. There are drips while removing the tank and I can see how it would leak if the tank wasn't properly seated, so I'm careful when its time to replace the water. I bought this to maintain my starting bioactive vivarium at a constant humidity. I had it hooked up to my starter tank for my snake and had it run off of a Spyder herpstat 2 to maintain a relative humidity of 75%. With the setup I had, It ran about 20 total minutes throughout the day (the thermostat would turn it on and off as needed to maintain humidity). I knew it was too tall to fit in the equipment area of the large vivarium I was building so it would be replaced with a different unit at the time of its completion. I probably bought and returned 5 different units trying to find one that fit, had enough flow, and didn't leak. I kept this one as a backup but it ended up being my main unit. I ultimately changed the design of my vivarium to fit this fogger because it's the only one I've gotten that has worked reliably over the past 2 years.

I made 2 custom habitats for a corn snake and a standard ball python. Four or five times a day had to open up the capartment's spray water immensely , Add Water to substrate because of Bottom heaters would dry them up quickly. Saw good reviews for this and for the price I figured I couldn't go wrong. Went with the two tube option to run both tanks since they are side by side. Might try to hide the tubes a little better or maybe go for the black ones to blend a little better but other than that works just as described. Quick little run to the local hardware store to get the caps and the nipples to insert in the tanks , gives a really good look and make it nice and and secure. Because if you have a snake you know they are Escape artists. Hooked it up to Mechanical timer plugged that into a surge protector strip and I am now a constant 70% humidity with slight temperature fluctuation. Maybe 2 to 3 degrees lower then before the fogger was installed. Quiet machine and does great job on low setting as well. Highly recommend.

Works really well, the flow isn't always a constant level tho. Like ot still flows but not at the same speed even if you don't adjust it. The auction cups it comes with don't really stick too well and when your trying to put the hose on top of a screen that doesn't have a hole to put a small hose in them you have to get creative on how to attach it. I ended up using a old plastic container with a rock inside to get the suction cup to stay on the bottom and the container on its side on top of my tank to get the hose to flow through the screen. Also since the other suction cup didnt want to stick on my tank I had to use a hairclip to attach the tube to my light holder. But once you get the hose the right way the machine works and runs pretty smoothly. Even with the flow issue its not really all that bad as it kinda stops the tank from being filled so quickly with fog.

2/2/22 tonight I removed the tank to refill it and heard a zapping noise like an electrical short. It will no longer power on. An electrical short when you're messing with a tank full of water well that's not a good thing so. This thing is straight garbage and possibly dangerous 12/29 I reached out to the company and they sent me a replacement. I will update after I have time to use it longer Update 12/8/2021 so my concern with the spring turned into a complete failure when the plug that keeps the water from pouring out when you turn the tank right side up to place it on the base and the spring and the plunger that opens up the plug all fell out. Now when I turn The tank right side up the water just pours out of it so I have to be quick. The humidifier is still working but I'm changing my review to one star because it didn't even make it 6 months before this part broke. I don't know maybe this one's just passed by quality control and shouldn't have for maybe they're all garbage. I'll be buying another similar humidifier just not this particular manufacturer. That's too bad an entire product can be undone by one crappy part. And apparently the manufacturer doesn't care. With all these one star reviews they have not bothered to respond to a single one. Is this a company you want to do business with? Original review So this thing works good. The only problem I've had is that the spring on the cap that holds the plunger in place so that it doesn't leak when you turn it right side up is too weak. So I have to put it in place quickly or it leaks everywhere. Otherwise it works fine

I originally bought one of these for my snake's enclosure in December of 2019. I set it up on a timer, and I loved how effective it was at keeping her tank humid. Used it for her tank for about two years, but, unfortunately, as soon as my ball python realized she could push the tube out of the hole I made in her wooden tank lid, she started using it as an escape route. So, I had to switch back to manually misting her tank. I ended up using it for my office plants since it's a great humidifier, and they've been absolutely thriving. Last week, after almost six full years of efficiency, it finally stopped making mist (I'm assuming it might be an issue with the atomizer?). Looking for a replacement, I realized that none of the competitors seem as durable and reliable as this one, so I dug through my old Amazon purchases until I was able to find this listing. I'm so glad it was still available, and everything is pretty much the exact same except for the color. Once I upgrade my snake's setup, I'll definitely be buying her another one. I highly recommend this to anyone needing a fogger for reptiles, terrariums, greenhouses, or houseplants.

I initially had really liked the product and my snake loved it as well. Now, after using it for a few months, I am starting to see issues. The top of the product is very flimsy and never closed properly. IF you fille dit too much it would spill everywhere and only last a few minutes. I thought, well maybe this is the way it is, but now it has stopped working completely. The water doesn't evaporate and instead gets stuck in the tube. I will have to go and look for another. I gave it three stars because when it worked, it was good, but now it's simply not working. You get what you paid I guess, I have no idea the ideal cost of these so I don't know if I went cheap and now I am suffering the consequences lol

Still going a year later! Works way better then a reptifogger! I replaced my old reptifogger two times within 6 months so I decided to give this one a try. So glad I did.

This unit has been a real workhorse. It was a little bit smaller than expected but I've had it running 24/7 for a little over a month with great success. If you run it at full power the fog lasts about 24+ hours. I use it at about 20-25% power and it lasts 4 days while maintaining around 65% (at day time) and 80% (at night time) humidity in my 25 gallon open top terrarium. The hose is collapsible, which is great, except that water will get trapped in the ridges. I worry that long-term, the hose will mold or grow algae, and I'm not sure how easy it is to find a replacement for this.I will give it six stars as it can be filled from top.

***If using in enclosed tank, lowest setting might be too much fog! (Get a cheap timer so it turns on/off automatically, this will also save you from refilling lots) -very good bendy stretchy tube -refill about once a day, more on highest setting (continuous spray) -impressive humidity output -fantastic alternative to name brand fogger -as you can see from the pictures I had dropped it and cracked a hole in the water container, but fixed it for like $6 with hot glue gun and plastic from glue gun packaging -I've had it for many months now without proper cleaning and it's doing a great job

Lamentable que este el producto en la pagina en español, y en ningún apartado ponga que no es clavija europea y funciona a 110v, encima dice que no se garantiza idioma de manual en español, pero ni el idioma ni que vaya a funcionar no? porque enchufarlo difícil.

Does the job great

1) Product didn’t come complete. Missing splitter or joint. 2) The light never turned green always red light. Basically it is not doing anything. 3) tried contacting the send multiple time to no reply.

Just got this and set it up right away. Instantly started making a TON of fog; I have it on the lowest setting possible and it's still more than enough for both tanks! Keeps my Ball pythons tank 55% and my crocodile skinks bioactive tank 82% all day with manual misting in the morning. You can hear it working but for the most part it's quiet. Love that it gives you two hoses and the adaptors for the single hose or dual hose option and 4 suction cups (I only needed one). The water tank seems a good size, especially if it does its job on the lowest setting. I'd say the only bad thing I can see right now is the fact that to fill the tank you need to remove the hose adaptor every time or remove the hoses from the tanks. At the moment I'm very pleased with my purchase and will update should anything go poorly.