TIG Stubby Gas Lens Body 17GL332 10N24S Glass Cup 12# kit 9pcs | Collet 10N24S 17GL332 3/32" 2.4mm and Quartz Nozzles #12 21.0mm Kit for DB SR WP 17 18 26 TIG Welding Torch

would buy again

Mounted this kit on a CK 17 RG. Very satisfied with the setup, AFTER doing four quick things that turned this from a “WTF?!?” experience into an “Awww yissss” one. 1) The white insulator / heat shield is a bit too small. Remedy option one: press the piss out of it. Remedy option two: heat gently… either with a heat gun, hair dryer, dunk in really hot water, etc. Will snap on like a charm. Not sure how easy it will be to remove… but I’ll find out some other day. 2) I had the .040 kit. Short gas cup. With the insulator bowing/bulging a but from being stretched to fit the torch body, it makes it tough to get the end of the cup to seat well over the rear o-ring. Remedy: use two o-rings. 3) O-ring on back cap is a little small. Not sure I would get a good seal back there on the torch body. Remedy: stick another one of the supplied o-rings on it! It seated perfectly between the rubberized torch body and the back cap lip when fully tightened onto the collet. 4) As mentioned in numerous other reviews, the gas cap is wobbly unless stabilized further down towards the tip somehow. The modification described by another reviewer worked precisely as described (put collet body into drill chuck and mill another o-ring groove into it). Good thing it comes with four o-rings, because ya end up using them all! See the photos I took of the finished product. All in all, if you’re willing to put about 10-15 minutes into tweaking the parts as described above, you’ll be quite pleased with what you got for the money. Four stars for the product… would have been five if it worked this well out of the box with no mods.

Very impressed! The cup is freaking huge, offering an extreme area of gas coverage. You get what you see, and nothing more..... I’ll buy again for sure!

Just returned this product because when assembled it didn't come with a gas lense for the cup and ruined my weld, and when I used another lense it wouldn't fit snug!! Just buy one that comes with the lense ready installed like i Just did, it's on the way!!

The insulator provided in this kit will not fit a CK 17 TIG torch even though is specifically says it will. You cannot use this kit with the CK size 17 torch. You need a 4GHS insulator for this to work.

Looks like a high quality gas lens.

Decent kit, for anyone wondering it's basically like a #13 cup size. Because they don't tell you and don't have the info, they told me lol.

It works great

Ok

届いた時点でガラスは、割れていました。使えません。残念です

Cracked cup not sure wether it was previously cracked or wether I had cracked it installing it

Angaben falsch,passt nicht für den WP26 Brenner. Brennerdüse ist zu kurz, der Dichtring liegt schon ganz an der Isolatorkappe an und somit kann der Glas Cup nicht aufgesteckt werden.