Prime-Line M 6228 Shower Door Bottom Sweep, 36 In. Length X 5/32 In. Wide, Vinyl, Clear (Single Pack)

This is an easy to install track mounted shower door sweep splashguard. It is designed to fit various size track on the shower door. Simply remove the old shower door sweep and slide the new sweep into place and cut to length, very easy and installed.

Works perfect for the glass shower door with metal bottom frame. Just make sure to remove the metal drip tray with a screw driver to remove / replace old one. Also recommend cleaning out the bottom (you'll see this once you remove the old one) before installing the new one. There will be allot of mold and crud. Other than than, its a one minute job to replace install but maybe 10 minutes of cleaning out the gunk form inside the door bottom.

I got this to replace the sweep on our shower. I don't know that this was exactly the right one, but it worked well once I installed it. You can see from the picture how it sits in the groove on the door frame. The only issue I had is that it came rolled up and it took several days of laying it flat and trapping it down to straighten it out. Also, one end was mangled. This ended up not mattering because I didn't need the whole length and I cut off the mangled part, but rolling it a little more carefully would have helped. That's the only reason for the 4 stars instead of 5.

Easy to install and cut to fit

Was really hard to get straight even with a hair dryer and ended up coming out after about a month

Bought this to repair bottom of shower door in my MH. This stuff is got to be packaged hot and rolled in a tight little wad with a rubber band around it to hold the mess together. Others have complained about the memory and used hot water to try to get it to release and well I found the same memory, tried the hot water to release it to no avail. It did sorta unroll some but when you streighten it out to go in the track on the door the flat part just gets wavy to the point there is no seal that can occur. I bought this to do a speedy repair, it should have been, but spent several hours trying to get this to work, no luck.It was fairly cheap but when you add my time trying to get it to work, well you know the rest of that story. TO PRIME LINE, if you are going to sell this **ap you need to add paper to the packaging. Do not buy unless you are a glutton for punishment! total JUNK, JUNK! And that's all I got to say about this.

Worked well. Kind of a pain to install on my shower door but it stops the water from leaking all over the floor.

Exactly what I needed

This rubber seal lasts far longer than the plastic clear one also available on Amazon. It's easy to feed into the t-slot at the bottom of the glass door, but only after you cut off the end, about 3/4 of an inch back. Then use a soapy finger and soap the top flat part of the t. It will slide right in. Make sure the part of the seal by the hinge is tucked inside the track for the door, if it is outside water will leak to the floor. Then trim the end to match the end of the door (handle side) and you're good. It will last years without having to replace if you don't use bleach to clean your shower. This is the 4th time I've replaced one of these in this house (lived here 14 years) and I know now to stick with this one (the grey rubber!).

This was a perfect fit for the bottom of our shower door. It was super easy to install and slid right into the grooves.

It’s pretty good and great Value for money

la bonne piece pour la réparation

Once the strip of plastic has been heated sufficiently (I used hot water in a pot) it smoothes out and is easy to install. It fits well. The seller should include "a straightening method" in the little brochure in the package.