WINSINN DC 80mm Fan 24V 8015 Dual Ball Bearing Brushless Cooling 80mmx15mm 2PIN (Pack of 2Pcs)

Go these to replace my dying fans on my m7 max resin printer and they are awesome not noisy at all and better than the original.

Direct plug n play replacement for the board fan in my anycubic kobra s1 3d printer. No modification necessary! And since it's a 2 pack o have a spare for next time it fails.I still have some winsinn fans on ye olde ender 3, and they're still going strong - they've lasted much longer than the original fans from creality that they replaced, so I have no issues buying these. No, they aren't super silent like noctua, but they're also like 1/6 the price of noctua. Plus they're WAY quieter than the buzzing/rattling sounds that the failing oem fans were making, so I'm happy.

Bought this to replace the fan on an anycubic vyper printer. Size wise it's a perfect fit however in the pictures of the fan they never show the other side of the fan. It has a recess on in my case on the side that mates to the cover. The blind thread inserts fit into this recess making the screws to long for mounting (the screws provided were of a different type) as they would bottom out. Not a big deal but I would have purchase a different fan had I known. Ended up putting a washer between the fan and thread insert which works fine so far. Overall noise wise I did notice any difference from the stock fan and yes I would buy again if it was not for the recess.

Direct replacement fan(s) for the Anycubic Photon Mono X. Six months and going strong and not too loud.

I purchased this to replace the stock main board cooling fan on my Sovol SV08 printer. The stock fan is much smaller and was very loud even when the printer wasn't printing. This fan, combined with a mount I found on Printables solved that problem and the machine is silent while not printing and much quieter during operation.

Replaced my noisy, rattling fan with this nice and quiet fan... then a month later it started whistling/screeching.

This was a perfect motherboard fan replacement for my Anycubic Kobra 2 Pro!

Good price. Packaging was nice, came in a little plastic case. Seem sturdy and moves decent air. I use them attached to the housing of a power supply to keep it cool. Previous fans lasted a few years in a dusty shop environment, then crapped out. Same ones were no longer available, so went with these. They move a good amount of air for their size, however if noise is a factor for you, I'd steer clear. Being in a shop, It matters none to me. But if I had these elsewhere , it would drive me nuts. A very steady hum and slight wine.

Purchased this fan to reduce noise level of stock fan. Turns out this one is same or little more noisy than stock. Also there is an effect on the prints especially PETG would dry sooner as the air flows into the chamber of Anycubic Kobra S1

Sehr gut geeignet als leise 12 V Lüfter.

They fit my printers well

TUDO OK

Voll krass, wenn man da Strom darufgibt, dreht sich der Lüfter.Ich habe einen der beiden Lüfter in meinen Anycubic Vyper eingebaut, weil der vorhandene Lüfter seine Arbeit eingestellt hatte. Der Lüfter passt, und die Geräuschentwicklung ist durchaus im Rahmen des erträglichen.