LutronDVSTV-WH Diva 8 Amp 3-Way/Single-Pole 0-10V Dimmer, no Neutral Required, White

I have been replacing all of my dimmers with this new generation and it is amazing how much better these are.I love the hidden minimum setting control, so you can be assured they will come on. With my pendants this allows down to night-light setting - below 10% - with no flicker at all.Very smooth control.This is ideal if you really want a paddle on/off and the slide is only to adjust when needed. I prefer that, especially as the min setting adjustment ensures it will always come on even if it a very low setting.

These are nice dimmers if you have the lights that need the 0-10V but they are expensive for what they do. They aren't smart or have any features like that.

Great product and worked wonderfully, but could only give it 4 starts because it was a little on the pricey side. I purchases a set of LED Panel Lights  2x2ft Dimmable 40w Led Panel Light Square Recessed Ceiling Lamp with LED Driver - 6000-6500k (Daylight White) - 3600lm - Smd2835 - 24"x24"  on Amazon, and after much investigation found that they required a DEDICATED low volt (10v) dimmer. Sounds simple enough, but I was surprised at how few of these there are out there. To make it even more difficult, most of those that are out there require the use of a secondary Power Pack to drive their dimming capabilities. The Lutron DVSTV fit the bill on both regards -- it had a dedicated 10v dimmer built into it, and it DOES NOT require as secondary power pack to hook it up.NOTE: Just be careful if you decide to order this and don't get it confused with the Lutron DVTV, which DOES require a secondary power pack. That extra "S" in the model name is really important.EXTRA NOTE: While a dedicated low voltage dimmer bit more hassle installing than I've typically experienced with dimmable lighting, I would say I now prefer a dedicated low voltage dimming solution. The dimming is much cleaner, more precise and crisp with absolutely no buzzing noises.

Installation is easy, if you can run the extra small-gauge wire pair for the 0-10V dimming through the wall to the switch. There is a low-end dial and a high-end dial setting you'll need to adjust, but otherwise, everything was easy to get working.The low setting isn't super dim, but seems to be about as low as the LEDs wish to go anyway. No complaints. The lowest setting is comfortably dim enough for going into the garage late at night without blowing out my retinas like 32 feet of bright LED tubes does at their highest setting!

Great dimmer for Sunco led 2x4 and 2x2 panels.

Could not find these at HD or Lowes - where staff did not even know what I was talking about. These are required for installing plat panel LED lights in drop ceiling - you have to run the extra control wire but it’s lightweight (like thermostat) wire so it’s easy. Controls multiple lights - works well. Standard dimmers will not work properly with flat panel LED’s, at least not the ones I bought. Redoing my basement drop ceiling so bought x4 of these to zone the lighting. Pricey but assuming they last I will be happy with them.

I've been replacing my 2x2 flourescent troffers with dimmable LED panels I got from Home Depot - Metalux brand. They require 0-10v dimming, so I picked up this switch for that purpose. It installs like any other light switch, except you have two extra leads for the dimming. Using some thermostat wire I ran the dimming up to a junction box where it then fans out to all the panels. Works perfectly! It's also nice that the dimming slider on this switch is as small as it is, so you are unlikely to accidentally adjust it when turning the rocker on and off.

It's a switch. It does what it says. It could be 5 star but it's extremely loud when turning off/on. I think that is likely quite characteristic of a rocker type switch but for the price, seems like the manufacturer could've done better.

this dimmer switch is very very cheap, the wire is made with super cheap steel not copper the wire it's so rigid, it's almost not foldable the dimmer housing it's made with cheap thin plastic like toy, do not buy this brand, leviton is by far superior

Works fine, but for what it is it’s ridiculously expensive. The problem is there is not many 0-10v options out there for some reason.

Got it cheaper here and it works perfectly with my 4 Philips Fluxstream strip lights.

Excellent produit

Needed a 0-10V for a single-pole.....well it connects but it won't dim!