TuTuYa Fender Flares, 4.9Ft/1.5m Universal Car Wheel Fender Extension Moulding Flares Auto Tyre Eyebrow Trim Strip Stick Out Edge,Pack of 4 Pcs

These rubber flare strips are good quality strips, tuff and durable. The only con was the adhesive that comes with it, it’s cheap and doesn’t stick well even with adhesive promoter. Do yourself a favor and replace the cheap adhesive that comes included with these rubber flare strips with some quality 3M 06382 OEM Black Automotive Acrylic Plus attachment tape on amazon. After I replaced the cheap molding tape, it worked awesome with the 3M 06382 tape. No way it’s coming off now. These manufacturers really need to get rid of the cheap molding tape and use real original 3M molding tape on their products instead.

The adhesive isn't that strong. I took my time preparing. 2 fell off the 1st day of driving. Then by day 3 they were all off. Very disappointing. Upsetting.

The fenders are EXCELLENT if you are looking for a small flare! They protrude about .5 of an inch from the body when installed. The adhesive is very good, just make sure to clean the surface with alcohol, very well, before you install! The only issue potentially, is making sure the flare is placed properly before installing. If not it will have an "out of round" look to it. PRO TIP....use a sharpie and a piece of cardboard. cut it into an "L" shape so you can have a guide to run along the inner fender. Tape the cardboard to the sharpie and make sure the cardboard is 1 inch distance from the tip when taped to the sharpie. It will make a perfectly spaced line on the car where the rubber fender can be placed. Hope that makes sense 🤷

I was looking for the same profile wheel well extensions and the only ones at a reasonable price are these available. Just because of the profile - we purchased them and didn't look back. See photos - we think it turned out quite well. We installed wheel extensions and about 1/2 inch were protruding, so these ones served quite well. Our installation was a bit tricky as we had to install on a plastic OEM trim. This option works well as it's not permanent yet sturdy. We prepped the plastic trim surface with adhesion promoter. If you are installing it on a metal surface, you will be fine with the current sticking tape. If your installation is onto plastic - we would recommend ordering a true 3M .75" roll of tape. We ordered a roll and will keep spare left for future projects. We pulled the existing tape off all four pieces. Took about 30 minutes. Than we prepped the surface of these flares with adhesion promoter as well. Than 3M tape went on. You can probably get away with a .5" tape, but we wanted to make sure that even corners would grip well onto plastic and went with a .75" width. We had a few funky curves to deal with on our new CRV, but these flares were flexible enough to be "molded" into plastic. Make sure to use a heat gun to warm up each flare for each wheel well with adhesive especially. A few runs up and down will do it. It cuts well with a very thin knife or a blade. You can trim it quite well. We used a half round knife (very thin) and carefully cut edges as needed. If this product was. 3M tape, we would have given 5 stars. But otherwise - at this price one cannot complain and definitely a good product.

Replaced supplied tape with 3M double sided tape. The flares are great. The tape supplied needs to be stronger.

They came on time !

This product is total garbage; the adhesive is not very strong at all and doesn't make a very large area of contact with the car. They fell off right after I put them on. They are now in the trash.

Worked well!