M-D Building Products 04226 37 in. Gray Vinyl Replacement Storm Door Bottom T-Shaped Insert

We've lived in this house for over 10 years and the screen/glass door looked old when we bought it. It's holding up well though but we noticed the weather stripping on the bottom of the door was breaking and tearing off. In our search to replace the old weather stripping we came across this product. It worked Great!! It was fairly easy to replace the old weather stripping we just needed to find the right product. This was it. The door is still old but it works like new now.

the repair man thought they would work on my storm doors. they didn't because the bottom wasn't tall enough.

I liked it, works perfectly.

I would have given this a 5 start but, it took 2 weeks to get all the kinks out because it was wrapped so tight in the bag. I had to use a pair of vice grips on each end, hung over a bar in a warm area, to stretch out the kinks. Once that was done the stripping worked great, a little silicone, it slipped right in.

It was a T shaped attachment for the rail inserted storm door sweep. Problem is, this one was nearly 1/4" and the channel in my storm door was a tad less than 3/16". I had to carefully trim it to fit which took much longer to do than it did to install it once trimmed. It works though. Dimensions of the "T" should be listed in product description.

New door seal wasn’t available locally. Was exactly what I needed. Good seller

Perfect fit.

Sweep for screen door. too wide, tried to cut down didn't work

Hard to put on

I like others purchased this product for due to the cost and the only available "T" replacement for the storm door. The cost is very economical but I also knew it would be a bit tricky to install. Like other reviews state you will certainly have to shave down one side (with a razor blade...that's what I used) for it to even fit in the track. Also use some oil on the track to get it to slide on after you shave the "T" a bit. So far seems to work as it should otherwise. Would be best if the manufacturer just made it the correct size. That would save a huge amount of time and fiddling with it. Took patience to get it in and x2 of them. It's definitely not a 5 min job. The 2nd one came all twisted and folded up too. Had to soak it in boiling water 1st to soften and make more pliable. If not you're not handy, you'd be fighting with this product. Overall, I would buy more of this product again if these were to change. Just need this one in a pinch.

How in the hell would this cover a small gap under your door . It's that small, you can't even tell its on. Garbage, don't buy if you have the slightest gap under your door, doesn't cover anything.

Too big for my slot in the door had to cut to fit.. happy now

As others have noted you will have to trim the "T" to get it to work. either carefully with scissors or otherwise. It fit fine after that