Heatshield Products 340410 Thermaflect Tape 4" Wide x 10' Heat Shield Tape

Adhesive is really good and sticks well. It does keep temperatures lower.

Just as described. I used to to make a sleeve for the electronic ribbon on the control panel for my Jenn Air Range. The weak link in this stove is that the heat from the oven causes this ribbon's components to separate and the panel quits working. So... Fingers crossed!

Good product, used it to cover a CAI on a 2000 Jeep Cherokee. Definitely does a good job of reflecting heat but the complaints about the glue are pretty much accurate. You may need to use zip ties to keep this tape in place. That being said it was very easy to work with even on 90 degree bends. The lack of super sticky glue could possibly be a pro instead of a con if you are using it temporarily.

Works like a charm. We had the glass on a nu wave oven break. We had this thing forever and it is well out of warranty. After applying this tape, it doesn't look pretty but still works. I took the broken piece and taped it on both sides(inside and outside the oven) and is still holding strong after several uses. The oven reaches reaches a consistent 350-400 degrees Fahrenheit anywhere from 15 min to an hour at a time. This thing is rated for much higher temps but can gladly say it works for me.

I bought this to line the inside of my lower race fairing on my 2006 CBR1000RR. I had previously used another brand of heat-shield tape and it wasn't doing the trick. Even with the exhaust wrapped and the other heat-shield tape on the lower fairing the paint was bubbling and discoloring. With this tape I no longer have the problem. This tape seems to be much thicker and the extra thickness seems to be for the insulation layer of the tape. As far as the adhesive goes it seems to be adhering well but some of the edges have needed to be pressed back down. The other thinner tape I used in the past has the same issue. I'm sure the problem is that if they make it too sticky you'll never get it off. As far as my needs go it is working perfectly.

Performed exactly as advertised. Used to shield plastic pipe and tank from a caravan heater exhaust. Gave it a really good test over the last weekend and had no worries. Adhesive is effective. Would recommend for ease of use and application.

Keeps intake piping cool to the touch even after long, hard drives. Air within the space of the heatshields is also far cooler than the rest of the bay. Great item and highly recommended for any aluminum intake piping. Make sure the surface is clean so the adhesive sticks properly.

I used this as well as ASIN B000E243AW to insulate a toaster oven for solder reflow purposes. It made a HUGE difference in the heat retention of the oven. This was very easy to work with and adhered quite well.