Ant Esports ICE-200TG Mid Tower Gaming Cabinet Computer case with RGB Front Panel Supports ATX, Micro-ATX, Mini-ITX Motherboard with Transparent Tempered Glass Side Panel,1 x 120 mm Rainbow Fan

The Antesports ICE-511 Cabinet offers good value for its price point, with decent build quality that exceeds expectations in this segment. For those seeking a non-RGB option, this cabinet delivers on aesthetics and airflow.However, there are some limitations to keep in mind. The LED lighting is static and cannot be controlled, which may be a drawback for some users. Additionally, while the cabinet provides good airflow, it would benefit from the inclusion of two more fans for optimal cooling performance.For those with m-ATX motherboards, it's important to note that space may be limited, particularly when attempting to install a liquid AIO cooler at the top. Extra connectors may also be required to properly connect the ARGB fans.Overall, the Antesports ICE-511 Cabinet offers a solid balance of aesthetics and airflow at its price point, making it a worthwhile consideration for budget-conscious builders. Just be aware of the potential limitations and the need for additional accessories to fully optimize your setup.

The media could not be loaded. The build quality is good, RGB is also good . Pretty spacious and good looking . Hardly makes any noise . Though the SSD fitting slot at the back was too thin to fit my SSD , had to hid it in back , but not a big issue . Also the screws were not aligned with the power supply , maybe because my power supply was smaller , but had to tie it with zipties instead and works completely fine.

it's a fine case with a few cons-1) the feet are very very low to the ground so the psu might not get a lot of intake air with this case. of you're going with a heavy psu then don't consider this case. i was fine with my gigabyte p550b psu though2) the lighting is NOT customisable even though they say that on their official website! you can't actually get the pretty blue colour shown in the photos, all you get is static rainbow coloured fans(see image). the fans are cheap molex connector fans(molex connector only allows power to pass through) so you won't be able to change their colours even if you buy a rgb controller.3) there's not much space for cable management but that's the same for almost any budget case. you can make it work.the 4 included fans are more than what most other other cases provide so it has good cooling and ample space for almost any build but the largest and most extreme ones. all the connectivity you would expect is here although there is only one usb 3.0 port and heaphone jack is combined for microphone and audio instead of split. it's more or less a pretty good case apart from the misleading advertising about fan lighting

The best case for this price pointPros:1)Rgb colors are cool.1)Tempered glass.2) Looks premium and material used for the metal parts are good.3) Big case with good airflow.Cons:1) Case comes with only one fan at the back2) Was actually scared about the front panel removal to install fans in the front because the material used is mediocre. (Check instructions below on how to remove front panel because you can't find it anywhere)3) Little bit more space for cable management would have been nice.For people who wants to install additional fans in the front follow the below steps:1) Clearly check how the front panel is mounted by the plastic panel holders in the sides of the case when viewing from the back.Check for lenght of the wire from the rgb strip in the front.2) Slowly apply slight pressure from the top and press the panel holders on both sides from the back and push the front panel edges with two hands on both sides.3)The whole front panel should come out immediately if even pressure is applied on both sides when the top holders are detached ,if not slowly apply pressure to detach all the panel holders.4) You can install upto max 2 * 120mm fans in the front.5) After installation align the panel holders onto the respective slot and push from the bottom on both sides and apply even pressure on both sides along the lenght of the front panel.Don't rush any steps at it might damage the front panel and cause rgb strip problems and obviously lead to return issues etc.Hope this helps !!!