Copper Foil Tape - 2" x 33' (1 Pack)

Great tape . I used this on the job , to plug RF leaks on one of my MRIs , Faraday cage . Works very well .

Bought this to shield a cheap Glarry five string bass I was modding. Worked perfectly. Zero buzz, hum or radio interference. Very easy to apply. Included photo is of the shielded bass control cavity with a Tonemonster preamp inside. 5/5 product. Absolutely buy this if your guitar needs shielding.

The right tape for the right gob. I used this to shield my P Bas guitar. right sizing/thickness and adhered to all parts of the body and plate. Was able to easily solder a wire to it for a solid grounding point to the rest of the guitar's grounds.

I coated 2" PVC to make it look like copper gutter, it takes a bit of time to apply to avoid wrinkles but I was able to get most out as they were little. There were some spots in a 10' pipe that wrinkled a bit due to an every so slight angle change but in the end, from 10 feet away...it looks like copper pipe. Fairly easy to use and get good results, smaller projects may be even easier.

Good tape, good thickness, good conductivity, good adhesive. Used to insulate guitar.

This was my first experience with shielding a guitar. I used this in a Squier strat that had terrible electromagnetic interference. The tape was easy to work with. I would test continuity every so often to make sure I was fully connected. I made sure each piece of tape overlapped the previous strip a little. I'm glad I chose the narrower tape, as wider may have been more difficult to work with. I used about half of the roll to completely shield all cavities. It seemed to have a good effect on my problem.

Why did you pick this product vs others?: Helped my noisy strat but didn't cure it. Not a miracle product, so don't expect a miracle. Expect a slight improvement and you'll be happy. Ymmv

I use this copper conductive tape inside my clothes dryer to reduce most of the static electricity that builds up. It holds up extremely well and stops most of the static (the magnets reduce the rest of the static as the electrically charged clothes fall through the magnetic field, causing a current to flow and balance out the charge).

Adhesive part of the tape is also conductive. So,Completely satisfied with this product.

Sticks well for a long time even with water splashing on it.

I bought this copper tape to make a "Faraday cage" in my electronic bass. That simply means lining the whole wooden cavity that encloses the sensitive electronics with a conductive layer of copper. This eliminates stray buzz, pops and other electronic noise interference. I worked in the electronics industry for many years. The tape worked extremely well. The conductive sticky side is a game changer- NO soldering needed to electrically bond the tapes together! Just over lap any joint a little. An Ohm meter consistently measured the joints electrical resistance to be virtually zero. The tape was super thin even when overlapping. This was a big plus where the copper tape was needed to be under various cover panel edges and channels. Great product. I would buy again. 10/10

Excellent product as advertised, works great for electric guitar shielding.

Put these around my half barrels and containers I grow vegetables and herbs in to keep slugs out.