10pcs 50kg Human Scale Load Cell Weighing Sensor Resistance Strain Half-Bridge Sensor 34x34mm DIY Kit

I've only tested four of the 10 load cells so far but they came right up and worked. I will be using them in a kitchen scale that is connected to a Raspberry Pi. The scale will measure one thing - a coffee maker - and every evening the Raspberry Pi will run a weight measurement and, based on the weight will send me an email if I've forgotten to set things up for coffee the next morning. From the limited testing I've done so far, these load cells will work perfectly for that purpose. There is one (very) minor thing to note - in one of the pictures the dimensions are listed as 3.4mm x 3.4mm. Clearly, this should be 34mm x 34mm. If this is not obvious to you, you probably should not be ordering them.

4 of the 6 load sensors were doa.

Works great in quarter, half, and full bridge config! Paired with an HX711 its produces steady and reliable results. Ive put over 30lbs on it with no issues at all.

Good product!