Hooke Road Fender Flares Front & Rear Mud Splash Guards Kit Compatible with 2018-2025 Jeep Wrangler JL Sahara Sport Sports (Exclude Rubicon)

After I removed the factory running boards from my Sahara and replaced them with step bars, I got a lot of gravel dings. These stopped that! Perfect finish and easy to install. Harbor Freight has the plastic rivet tool you’ll need for cheap. Thanks for a great product!

Super value. I have two jeeps. I have OEM flaps on one, and these on the other. Both are made of the same material, have the same exact dimensions, and look the same except the OEM product has the Jeep logo. But at 1/4 the cost of OEM, Ill take these all day long. I highly recommend.

Does not fit my 2023 Jeep Wrangler 4ex. It did not come with mounting hardware, and after I contacted seller they said it would be shipped in 15 days. It’s end of June and hardware didn’t come and I can’t return product.

Splash guards fitment is very good on my 2019 JLU Sahara and should do the job. A couple issues I have with these 1). The flaps have a rather large ridge around the inside, probably for stability, that I'm sure will hold dirt, mud and definitely snow and ice. It will be awhile before we see snow here in the northeast so I won't know how bad it will be for awhile. But I foresee a lot of snow and ice buildup. The other issue is the plastic rivet installation which may have been more difficult for me due to the cheap Harbor Freight rivet gun I purchased. It was just a bit of a pain. Also, there is one wheel well screw in back on each side that is removed/reused to hold the bottom of the splash guard. I found the splash guard did not fit nicely flush into the wheel well which made it difficult to get the screw started (too short). I had to jack up the Jeep to get enough room for leverage to push the guard flush with the wheel well to get the screw started.

These were super easy to install - yes you need to drill one hole on each front one - but it was simple. You do need a plastic rivet gun - the 15$ Amazon one worked fine. I would grab a trim pry bar for removing the old rivets if I were to do it again - but a razor blade and screwdrivers worked fine ultimately.

Great for a couple years, then material too brittle and may crack. Installation was easy. Looked really nice until it cracked. I'll be looking for material that's a little bit softer for replacement of these.

Look great and seem pretty ridged, great price and fit perfectly on my wife's wrangler sahara unlimited. You will need to purchase a plastic rivet tool to install these.

No instructions. You'll need a 1/4 inch drill bit, a rivet gun for plastic rivet,and id recommend some additional rivets as well as automotive plastic push pin connectors. Available at harbor freight. On the rear wheels of the Wrangler,forget about removing the factory screw on the inner fender liner,it will be too short to adequately re use. Drill an additional hole in the lower fender flare and add a plastic push pin or additional rivet. The rivets they send with these are garbage. The fit once completed is pretty good.

well made,it fits my jeep jl 2 door 2025 very pleased

2021 Wrangler Willys Unlimited.Fitting is good. Wont fit jeeps that have rock guards. I have aftermarket running boards. Takes some creativity to install but overall, it was ok. I ended up using my own PUSH rivets. The ones that come with it require a rivet gun. No instructions

Mud flap ne correspond pas avec le vheicul (surtout en arrière

Front is direct fit use existing holes, rear will need drilling holes in fender. you’ll also need plastic riveting tool if using the included plastic rivets. Looks good on 21 Jeep Wrangler.

The product did not fit. It cost too much to return.